HENDERSON, NV —
OSHA Inspection: HARRIS & RUTH PAINTING CONTRACTING, INC.
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of HARRIS & RUTH PAINTING CONTRACTING, INC. in 1550 HORIZON RIDGE, HENDERSON, NV 89012 (NAICS 238320). OSHA activity number 310422027.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- HARRIS & RUTH PAINTING CONTRACTING, INC.
- Site address
- 1550 HORIZON RIDGE
- City
- HENDERSON
- State
- NV
- ZIP
- 89012
- Mailing
- 6252 SMALL POINT DRIVE, LAS VEGAS, NV 89108
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238320
- SIC code (legacy)
- 1721
- Employees
- 20
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
2 citations on file for this inspection.
618037501
- Issued
- Sep 14, 2006
- Abate by
- Sep 19, 2006
- Penalty
- Initial $375 · Current $375
General-duty citation text
Nevada Revised Statute 618.375(1): The employer did not furnish employment and a place of employment which was free from recognized hazards that were causing or likely to cause death or serious physical harm to employees: The employer failed to ensure fall protection was used as follows: (a)At the east front of the Parkridge Center, at Parkridge Dental, an employee was riding and painting inside a green model 400S aerial lift, Sunbelt Rental, serial number 65156. The employee was painting approximately 16 feet high, and was not wearing fall protection as required. No fall protection harness was on the work site at the time of the incident. Reference: ANSI A92.5 - 1992 Boom-Supported Elevating Work Platforms: Section 7.3.3 Pre-Start Inspection: Before use each day or at the beginning of each shift, the aerial platform shall be given a visual inspection and functional test including but not limited to the following: (c) Personal protection devices, including fall protection. Section 8.8 During Operation: The aerial platform shall be used in accordance with this standard. The operator shall ensure the following before each elevation of the platform: (g) Ensure all personnel in the platform are wearing fall protection devices and other safety gear as required at all times. One feasible means of abatement is to make sure that the proper personnel fall protection equipment required to do the job is provided and utilized.
618037601
- Issued
- Sep 13, 2006
- Abate by
- Sep 29, 2006
More inspections at Harris & Ruth Painting Contracting, INC.
View Harris & Ruth Painting Contracting, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238320)
More inspections in NV
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 310422027.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.