DUBLIN, OH —
OSHA Inspection: ALLSTATE
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of ALLSTATE in 5605 WOEHNER-TEMPLE ROAD, DUBLIN, OH 43016 (NAICS 238130). OSHA activity number 310483672.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ALLSTATE
- Site address
- 5605 WOEHNER-TEMPLE ROAD
- City
- DUBLIN
- State
- OH
- ZIP
- 43016
- Mailing
- 8103 EAST 46TH ST., SUITE 7, INDIANAPOLIS, IN 46226
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- SIC code (legacy)
- 1751
- Employees
- 4
- Ownership type
- A
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- Feb 12, 2008
- Abate by
- Feb 22, 2008
- Penalty
- Initial $300 · Current $300
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the following: a. On the site, the employer did not ensure the safety platform used to lift prsonnel was not more the 10 inches wide on each side of the load bearing wheel base and that it was equipped with an adequate guardrail system. Among the feasible means of abatement that can be used to correct this are: Utilize only platforms which meet the requirement set forth in ANSI/ASME B56.6-2002, section 8.24.1(b), in that the width of the platform shall not exceed ten inches on either side of the load bearing wheel base of the forklift and section 8.24.1(l), the platform shall be equipped with a guardrail that has a nominal height to the platform floor of 42 inches and include a midrail.
1926.102 A01
- Issued
- Feb 12, 2008
- Abate by
- Feb 22, 2008
- Penalty
- Initial $300 · Current $300
1926.602 C01 VIIIA
- Issued
- Feb 12, 2008
- Abate by
- Feb 22, 2008
- Penalty
- Initial $225 · Current $225
More inspections at Allstate
View Allstate's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 310483672.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.