OSHA Inspection: MAGENTA CORPORATION

Issued

Nov 28, 2006

Abate by

Dec 1, 2006

Penalty

Initial $3,500 · Current $2,000 Reduced

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to:
a) Maintenance Area and Quality Control Room- On or about November 2,
2006, the equipment
such as, but not limited to; the Roll-In Vertical Bandsaw in the and the
Delta Vertical Bandsaw
were not equipped with a device to prevent the saw's motor from
automatically restarting after
power was restored.
Among other methods, one feasible and acceptable method to correct this
hazard is to include,
but not be limited to the following:
1) Provide a magnetic restarter or similar device as required by the
American National Standards
Institute (ANSI) B11.10-2003 Section 6.11, that in the event of an
interruption
in the electrical
supply would prevent the saw from restarting automatically when power is
restored.
No abatement certification or documentation required for this item.

Issued

Nov 28, 2006

Abate by

Feb 2, 2007

Penalty

Initial $2,450 · Current $1,470 Reduced

Issued

Nov 28, 2006

Abate by

Dec 15, 2006

Penalty

Initial $2,450 · Current $1,470 Reduced

Issued

Nov 28, 2006

Abate by

Dec 15, 2006

Penalty

Initial $2,450 · Current $1,470 Reduced

Issued

Nov 28, 2006

Abate by

Mar 2, 2007

Penalty

Initial $3,500 · Current $2,100 Reduced

Issued

Nov 28, 2006

Abate by

Dec 1, 2006

Penalty

Initial $3,500 · Current $2,100 Reduced

Issued

Nov 28, 2006

Abate by

Dec 15, 2006

Penalty

Initial $3,500 · Current $2,100 Reduced

Issued

Nov 28, 2006

Abate by

Jan 2, 2007

Penalty

Initial $2,450 · Current $1,470 Reduced

Issued

Nov 28, 2006

Abate by

Jan 2, 2007

Issued

Nov 28, 2006

Abate by

Dec 15, 2006

Penalty

Initial $700 · Current $420 Reduced