Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,645Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: LEACH'S CUSTOM TRASH

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of LEACH'S CUSTOM TRASH in ROUTE 281, HOMER, NY 13077 (NAICS 562111). OSHA activity number 310750302.

Watch Leach'S Custom Trash — free Get an email when a new federal OSHA severe-injury report for Leach'S Custom Trash is published. One employer, no account, unsubscribe in one click.
Site address
ROUTE 281
City
HOMER
State
NY
ZIP
13077
Mailing
1834 ROUTE 13 NORTH, CORTLAND, NY 13045
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
562111
SIC code (legacy)
4212
Employees
6
Ownership type
A

1 citation on file for this inspection.

5(a)(1)

Other-than-serious Gravity 03 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $750.00 · Current $375.00 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized
hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to THE HAZARD OF BEING STRUCK-BY VEHICLES and TRAILERS:
a) On or about 8/6/07, Route 281:  The employer failed to:
1) Prohibit employees from riding on locations that were not located behind
the rear most axle, and were not created with a self cleaning surface.
2) Prohibit the use of a rear loading garbage truck while a trailer was
attached.
3) Prohibit employees from riding external steps when speeds exceeded 10
mph and when the travel distance between stops exceeded 2/10 of a mile.
4) Remove or block the riding steps located on the garbage truck when a
trailer was in use.
5) Provide warning signs located on the trailer indicating to employees
when
riding on steps was prohibited.
Among other methods of abatement, one feasible and acceptable means of
abatement
is to follow the American National Standards Institute (ANSI) Z245.1
requirements
for refuse collection, processing, and disposal equipment - Mobile Refuse
Collection
and Compaction Equipment - Safety Requirements.  Sections 6.1(n), 6.1(m),
6.2.4,
7.1.10, and 7.1.12.6.
Abatement certification must be submitted for this item.
Recent events (2)
  • — J (O) $375.00
  • — Z (S) $750.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 310750302.