MINT HILL, NC —
OSHA Inspection: ROBERTO ROBLETO DBA RCR CONSTRUCTION
Planned inspection · Health discipline
At a glance
On , OSHA opened a planned health inspection of ROBERTO ROBLETO DBA RCR CONSTRUCTION in 13125 ZEB MORRIS WAY, MINT HILL, NC 28227 (NAICS 238310). OSHA activity number 310881644.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ROBERTO ROBLETO DBA RCR CONSTRUCTION
- Site address
- 13125 ZEB MORRIS WAY
- City
- MINT HILL
- State
- NC
- ZIP
- 28227
- Mailing
- 1950 WINDSOR HILL DRIVE, APT M, MATTHEWS, NC 28105
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238310
- SIC code (legacy)
- 1742
- Employees
- 2
- Ownership type
- A
- Industry flags
- Construction health.
Citations
2 citations on file for this inspection.
95012901
- Issued
- Feb 20, 2007
- Abate by
- Feb 23, 2007
- Penalty
- Initial $300 · Current $300
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to a fall hazard of approximately 15 feet to the ground below: a)jobsite, an employee was observed standing on the mid-rail of a JLG scissor lift installing tar paper sheeting. Among other methods, one feasible and acceptable abatement method to correct this hazard is to ensure that employees only stand on the work platform and not climb on the mid-rail or top-rail unless adequate fall protection is provided. Reference: ANSI A92.6 - 1999 American National Standard for Self-Propelled Elevating Work Platforms, Section 8.10(9).
1926.416 E01
- Issued
- Feb 20, 2007
- Abate by
- Feb 23, 2007
More inspections in this industry (NAICS 238310)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 310881644.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.