TYBEE ISLAND, GA — 2010-02-24 00:00:00

OSHA Inspection: FRYE, INC.

Planned inspection · Safety discipline

At a glance

On 2010-02-24 00:00:00, OSHA opened a planned safety inspection of FRYE, INC. in 8 18TH ST., TYBEE ISLAND, GA 31328 (NAICS 238130). OSHA activity number 310996947.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Frye, INC. — free Get an email when a new federal OSHA severe-injury report for Frye, INC. is published. One employer, no account, unsubscribe in one click.

Where did this inspection happen?

Establishment: FRYE, INC.
Site address: 8 18TH ST.
City: TYBEE ISLAND
State: GA
ZIP: 31328
Mailing: P.O. BOX 775, MILLEN, GA 30442

What kind of inspection was it?

Inspection type: Planned (H)
Scope: Complete (A)
Discipline: Safety
Advance notice: No
Union status: N

When did the case open and close?

Opened: 2010-02-24 00:00:00
Closing conference: 2010-02-24 00:00:00
Case closed: 2010-11-30 00:00:00
Last modified: 2010-11-30 00:00:00
Data loaded: 2011-10-14 16:38:47

Establishment context

NAICS code: 238130
SIC code (legacy): 1751
Employees: 3
Ownership type: A

Citations

12 citations on file for this inspection.

5(a)(1)

Serious Gravity 02 1 instance 1 exposed

Issued: Jun 15, 2010
Abate by: Jul 9, 2010
Penalty: Initial $600 · Current $600

General-duty citation text

P.L. 91-596 Section 5(a)(1) of the Occupational Safety and Health Act of
1970: The employer
did not furnish employment and a place of employment which were free from
recognized hazards
that were causing or likely to cause death or serious physical harm to
employees in that
employees were exposed to the hazard(s) of:
a)On or about February 24, 2010, south side of the 2nd level, an employee
was
using a job-made ladder that did not have filler blocks inserted between
the cleats,
exposing the employee to a fall hazard of up to 8 feet.
Among other methods, one feasible and acceptable method to abate the
hazardous condition
would be to construct the ladder in accordance with American National
Standards Institute
(ANSI) A14.4-1979, Safety Requirements for Job-Made Ladders, section 4.5.2
.
ABATEMENT CERTIFICATION IS REQUIRED.TION