Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: YOUNGQUIST BROTHERS, INC

Accident-driven inspection · Safety discipline

On , OSHA opened an accident-driven safety inspection of YOUNGQUIST BROTHERS, INC in 33100 TAMIAMI TRAIL RACOON POINT # 2, OCHOPEE, FL 34141 (NAICS 213111). OSHA activity number 311087308.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Youngquist Brothers, INC — free Get an email when a new federal OSHA severe-injury report for Youngquist Brothers, INC is published. One employer, no account, unsubscribe in one click.
Site address
33100 TAMIAMI TRAIL RACOON POINT # 2
City
OCHOPEE
State
FL
ZIP
34141
Mailing
15465 PINE ROAD, FT. MYERS, FL 33908
Inspection type
Accident-driven (A)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
213111
SIC code (legacy)
1381
Employees
20
Ownership type
A

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 1 exposed
Issued
May 9, 2008
Abate by
May 14, 2008
Penalty
Initial $5,600 · Current $5,600
Section 5(a)1 of the Occupational Safety and Health Act of 1970:
The employer did not furnish to each of his employees employment and a
place of employment
which were free from recognized hazards that were causing or likely to
cause death or serious
physical harm to employees in that employees were exposed to struck-by
hazards:
On or about 11/17/07, at 33100 Tamiami Trail Racoon Point #2, an employee
was exposed to
an injury after striking against a rod basket while guiding a testing rod
onto a holding rack due
to the derrick operator's failure to observe and control the load, to
include but not limited to
inadequate communication.
Among others, one feasible and acceptable method of abatement is to
develop and implement
in accordance with API RP 54, Recommended Practice for Occupational Safety
for Oil and Gas
Well Drilling and Servicing Operations, Section 9.6.7 loads shall not be
allowed to come in
contact with any part of the derrick, mast or other stationary equipment,
as well as, Section 12.3
to provide and use adequate communication methods.ation

View Youngquist Brothers, INC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 311087308.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.