ADDISON, IL · 2007-10-30 00:00:00

OSHA Inspection: ANIL PLUS CORPORATION DBA MIDAS

Complaint inspection · Safety discipline

At a glance

On 2007-10-30 00:00:00, OSHA opened a complaint safety inspection of ANIL PLUS CORPORATION DBA MIDAS in 20W536 LAKE STREET, ADDISON, IL 60101 (NAICS 811111). OSHA activity number 311245609.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Anil Plus Corporation DBA Midas for free Get an email when a new federal OSHA severe-injury report for Anil Plus Corporation DBA Midas is published. One employer, no account, unsubscribe in one click.

Where did this inspection happen?

Establishment: ANIL PLUS CORPORATION DBA MIDAS
Site address: 20W536 LAKE STREET
City: ADDISON
State: IL
ZIP: 60101

What kind of inspection was it?

Inspection type: Complaint (B)
Scope: Partial (B)
Discipline: Safety
Advance notice: No
Union status: N

When did the case open and close?

Opened: 2007-10-30 00:00:00
Closing conference: 2007-11-01 00:00:00
Case closed: 2008-04-18 00:00:00
Last modified: 2008-04-18 00:00:00
Data loaded: 2011-10-14 16:38:47

Establishment context

NAICS code: 811111
SIC code (legacy): 7538
Employees: 5
Ownership type: A

Citations

8 citations on file for this inspection.

5(a)(1)

Serious Gravity 01 1 instance 5 exposed

Issued: Nov 30, 2007
Abate by: Dec 7, 2007

General-duty citation text

Each employer shall furnish to each of his employees employment and a
place of employment
which are free from recognized hazards that are causing or are likely to
cause death or serious
physical harm to employees in that employees were exposed to possible
crush hazards from
falling vehicles while working with defective automotive lifts that had
not been properly
inspected, repaired or taken out of service.
a.The "truck lift" Bay 8, was not repaired after the lift began moving up
and or
down on its own.
b.Bay 4, Rotary lift was not inspected to determine that the lift could be
lowered
using only one hand lever where it is designed to be lowered using 2 hand
levers.
c.Removal from Service - Defective lifts were not removed from service by
the
employer, "Truck Lift" Bay 8 and Bay 4 Rotary lift. (ANSI/ALI-ALOIM 4.5)
d.The employer did not follow the recommended inspection procedures of the
lift
manufacturer. (ANSI/ALI-ALOIM 2000, 5.4 - 5.5)
Some feasible means of abatement would include:
1.Establish compliance with the American National Standards
Institute/Automotive
Lift Institute Standards ANSI/ALI-ALOIM-2000 "Standard for Automotive
Lifts -
Safety Requirements for Operation, Inspection and Maintenance.
2.Have lift operators conduct daily or pre-shift inspections and develop
mechanisms
for operators to report problems to management.
3.When problems with lifts are reported, ensure appropriate inspection.
4.Remove defective lifts from service until repaired and in safe working
condition.

Recent events (2)

2007-12-26 00:00:00 · I (S)
2007-11-30 00:00:00 · Z (S)

1910.133 A01

Serious Gravity 01 3 instances 5 exposed

Issued: Nov 30, 2007
Abate by: Dec 10, 2007

Recent events (2)

2007-12-26 00:00:00 · I (S)
2007-11-30 00:00:00 · Z (S)

1910.151 C

Serious Gravity 04 1 instance 5 exposed

Issued: Nov 30, 2007
Abate by: Dec 17, 2007

Recent events (2)

2007-12-26 00:00:00 · I (S)
2007-11-30 00:00:00 · Z (S)