SAN ANTONIO, TX —
OSHA Inspection: D & M WELDING
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of D & M WELDING in 23535 I H 10 W., SAN ANTONIO, TX 78257 (NAICS 238120). OSHA activity number 311309819.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- D & M WELDING
- Site address
- 23535 I H 10 W.
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78257
- Mailing
- 13574 FM 1560, HELOTES, TX 78023
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238120
- SIC code (legacy)
- 1791
- Employees
- 4
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Nov 23, 2007
- Abate by
- Nov 29, 2007
- Penalty
- Initial $600 · Current $360 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of falls: (a)At the construction site where the scissor lift operator was standing on the top rail of the Genie GS 2032 scissor lift, elevated to approximately 17 feet above the ground level, while installing sheet metal studs to the front of the building: Among other methods, one feasible and acceptable abatement method to correct these hazards is to comply with the manufacturer's requirements and ANSI/SIA A92.6-1990 for Self-Propelled Elevating Work Platforms. Section 8.10.1 Personnel Footing: Personnel shall maintain a firm footing on platform while working thereon. Use of planks, ladders, or any other devices on the platform for achieving additional height or reach shall be prohibited.
Recent events (2)
- — I (S) $360.00
- — Z (S) $600.00
More inspections at D & M Welding
View D & M Welding's full OSHA safety record →
More inspections in this industry (NAICS 238120)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 311309819.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.