MALTA, ID ·
OSHA Inspection: LAYNE PUMPS, INC
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of LAYNE PUMPS, INC in 1625 S HWY 81, MALTA, ID 83342 (NAICS 423830). OSHA activity number 311577274.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- LAYNE PUMPS, INC
- Site address
- 1625 S HWY 81
- City
- MALTA
- State
- ID
- ZIP
- 83342
- Mailing
- 3797 NORTH 3400 EAST, TWIN FALLS, ID 83303
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 423830
- SIC code (legacy)
- 5084
- Employees
- 18
- Ownership type
- Private (A)
Citations
7 citations on file for this inspection.
5(a)(1)
- Issued
- Aug 28, 2008
- Abate by
- Jan 9, 2009
- Penalty
- Initial $2,100 · Current $1,100 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which was free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of structural collapse and failure of the crane and critical components: a)In the workplace: On July 18, 2008 and times prior thereto, the employer did not ensure that periodic inspections, were being conducted on the R3 rig, used to install water irrigation pumps and associated piping weighing approximately 15,000 to 20,000 pounds. b)In the workplace: On July 18, 2008 and times prior thereto, the employer did not ensure that a rated load capacity was determined, including but not limited to loads which may be imposed laterally from side loading, for the R3 rig prior to putting it into service. Note 1) Instance a) Feasible and acceptable abatement to correct this hazard is to comply with ANSI B30.5-1968 Crawler, Locomotive and Truck Cranes, section 5-2.1.3 Periodic Inspections, and/or ANSI B30.6-1969 Derricks, section 6-2.1.3 Periodic Inspections, which include, but are not limited to parts such as pins, bearings and shafts for wear, cracks and distortion, with a written, dated, and signed record of the inspection results. Note 2) Instance b) Feasible and acceptable abatement to correct this hazard is to comply with ANSI B30.5-1968 Crawler, Locomotive and Truck Cranes, section 5-2.1.1 Load Ratings-Where Stability Governs Lifting performance, and/or section 5-1.1.2 Load Ratings- Where Structural Competence Governs Lifting Performance. Note 3) Abatement certification and documentation is required for this item.
Recent events (3)
- · P (S) $1100.00
- · I (S) $1100.00
- · Z (S) $2100.00
1910.157 C01
- Issued
- Aug 28, 2008
- Abate by
- Sep 24, 2008
- Penalty
- Initial $450 · Current $225 Reduced
Recent events (2)
- · I (S) $225.00
- · Z (S) $450.00
1910.157 E03
- Issued
- Aug 28, 2008
- Abate by
- Sep 24, 2008
Recent events (2)
- · I (S)
- · Z (S)
1910.215 A04
- Issued
- Aug 28, 2008
- Abate by
- Sep 4, 2008
- Penalty
- Initial $450 · Current $225 Reduced
Recent events (2)
- · I (S) $225.00
- · Z (S) $450.00
1910.215 B09
- Issued
- Aug 28, 2008
- Abate by
- Sep 4, 2008
Recent events (2)
- · I (S)
- · Z (S)
1910.110 D10
- Issued
- Aug 28, 2008
- Abate by
- Sep 4, 2008
Recent events (2)
- · I (O)
- · Z (O)
1904.29 B01
- Issued
- Aug 28, 2008
- Abate by
- Sep 3, 2008
Recent events (2)
- · I (O)
- · Z (O)
More inspections in this industry (NAICS 423830)
More inspections in ID
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 311577274.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.