HENDERSON, NV —
OSHA Inspection: PARAGON CONTRACTORS CORPORATION
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of PARAGON CONTRACTORS CORPORATION in 1057 WHITNEY RANCH ROAD, HENDERSON, NV 89014 (NAICS 238130). OSHA activity number 311643316.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- PARAGON CONTRACTORS CORPORATION
- Site address
- 1057 WHITNEY RANCH ROAD
- City
- HENDERSON
- State
- NV
- ZIP
- 89014
- Mailing
- P.O. BOX 841665, HILDALE, UT 84784
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- SIC code (legacy)
- 1751
- Employees
- 12
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
1 citation on file for this inspection.
618037501
- Issued
- May 12, 2008
- Abate by
- May 15, 2008
- Penalty
- Initial $375 · Current $375
General-duty citation text
Nevada Revised Statute 618.375(1): The employer failed to furnish employment and a place of employment which was free from recognized hazards that were causing or were likely to cause death or serious physical harm to his employees: The employer failed to ensure employees were protected from falling as follows: (a)At the Zockell Phase 3 construction site, an employee setting a wood beam worked from a personnel platform attached to the forks of a Sky Trak 8042 rough terrain forklift. The employee was not wearing a body harness with lanyard attached for fall protection, and stood on the midrail of the platform and leaned out over the edge. The platform used lacked markings for capacity and maximum personnel. The employee was exposed to possible serious injuries or death from a fall of up to approximately 40 feet to the ground or structure below. Reference: ASME B56.6 - 1992: Safety Standard for Rough Terrain Forklift Trucks: Section 5.15 Elevating Personnel (k) Be certain that required restraining means such as railings, chains, cable, body belt(s) with lanyard(s), etc., are in place and properly used. (u) Personnel are to maintain firm footing on platform floor unless secured by body belt and lanyard. Use of railings, planks, ladders, etc., on the platform for purpose of achieving additional reach or height is prohibited. Section 8.24 Platforms for Elevating Personnel 8.24.1 Design requirements for the manufacture of the platform shall include the following: (f) information prominently indicated on the platform: (1) maximum work load including personnel and equipment; (2) weight of empty platform. One feasible means of abatement would be to follow the requirements of ASME B56.6 - 1992.
More inspections at Paragon Contractors Corporation
View Paragon Contractors Corporation's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in NV
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 311643316.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.