GREENSBORO, NC —
OSHA Inspection: RBE CONSTRUCTION, LLC
Unprogrammed Other inspection · Health discipline
At a glance
On , OSHA opened an unprogrammed Other health inspection of RBE CONSTRUCTION, LLC in 3516 / 3518 S. ELM - EUGENE STREET, GREENSBORO, NC 27401 (NAICS 238130). OSHA activity number 312191885.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- RBE CONSTRUCTION, LLC
- Site address
- 3516 / 3518 S. ELM - EUGENE STREET
- City
- GREENSBORO
- State
- NC
- ZIP
- 27401
- Mailing
- 7319 LEDBETTER ROAD, CLIMAX, NC 27233
What kind of inspection was it?
- Inspection type
- Unprogrammed Other (I)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- SIC code (legacy)
- 1751
- Employees
- 12
- Ownership type
- A
- Industry flags
- Construction health.
Citations
1 citation on file for this inspection.
95012901
- Issued
- Aug 19, 2008
- Abate by
- Aug 22, 2008
- Penalty
- Initial $1,050 · Current $1,050
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees conditions of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees, in that employees were exposed to, 1) a fall from an elevation of approximately 20 feet and/or 2) being struck by or crushed by the "home-made" bucket attachment tied to the mast with two nylon strips, and/or 3) being struck by or crushed by or the JGL Skytrak forklift outfitted with the "home-made" bucket attachment not approved by the manufacturer, effecting the center of gravity of the forklift. a)jobsite - 3516 S. Elm - Eugene Street, Greensboro, NC. - a framing employee was in a "home-made" bucket attachment on a JGL Skytrak Telehandler (Hertz Rental Equipment number 412-08-5040) raised to a level which allowed access to a third story window approximately 25 feet above the ground level. The "home-made" bucket attachment was tied to the forklift mast with two makeshift ties and was completely open on the front side. The "home-made" attachment had not been approved by the manufacturer of the forklift. Among other methods, one feasible and acceptable means of abatement is to use only attachments approved by the manufacturer for this specific type of forklift and for the occupation and transport of personnel.
More inspections at RBE Construction, LLC
View RBE Construction, LLC's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 312191885.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.