LITTLE ROCK, AR —
OSHA Inspection: MTG METAL ERECTORS, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of MTG METAL ERECTORS, INC. in 10300 ARCH ST. PIKE, LITTLE ROCK, AR 72206 (NAICS 238390). OSHA activity number 312209414.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MTG METAL ERECTORS, INC.
- Site address
- 10300 ARCH ST. PIKE
- City
- LITTLE ROCK
- State
- AR
- ZIP
- 72206
- Mailing
- 909 W. MAIN, JACKSONVILLE, AR 72076
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238390
- SIC code (legacy)
- 1761
- Employees
- 7
- Ownership type
- A
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Oct 8, 2008
- Abate by
- Oct 15, 2008
- Penalty
- Initial $750 · Current $750
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: On or about September 11, 2008, on the north side of the new pre-fabricated metal warehouse building located at Porocel Corporation, 10300 Arch Street Pike, Little Rock, Arkansas, an employee was in an elevated scissor lift directly beneath a suspended load of roofing panels estimated to weigh approximately 900 lbs. The employee was stretching insulation around the eave of the roof and was exposed to being crushed by the suspended load if the hydraulics on the Skytrak that was being used to elevate the load inadvertently failed and the lifting components dropped. One feasible means of abatement would be to not allow employees to stand or pass under the elevated portion of any rough terrain forklift truck, whether empty or loaded as referenced in ASME B56.6.6 - 2002, Safety Standard for Rough Terrain Forklift Trucks. In the alternative, place loads on top of roofs and then elevate employee(s) in scissor lift to desired working height.
1926.20 B01
- Issued
- Oct 8, 2008
- Abate by
- Oct 21, 2008
- Penalty
- Initial $450 · Current $450
1926.21 B02
- Issued
- Oct 8, 2008
- Abate by
- Oct 15, 2008
- Penalty
- Initial $450 · Current $450
1926.501 B01
- Issued
- Oct 8, 2008
- Abate by
- Oct 15, 2008
- Penalty
- Initial $1,500 · Current $1,500
More inspections in this industry (NAICS 238390)
More inspections in AR
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 312209414.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.