JACKSONVILLE, AL —
OSHA Inspection: ANNISTON CONCRETE AND ASPHALT CO
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of ANNISTON CONCRETE AND ASPHALT CO in 1000 GEORGE DOUTHIT DRIVE SW, JACKSONVILLE, AL 36265 (NAICS 237990). OSHA activity number 312214141.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ANNISTON CONCRETE AND ASPHALT CO
- Site address
- 1000 GEORGE DOUTHIT DRIVE SW
- City
- JACKSONVILLE
- State
- AL
- ZIP
- 36265
- Mailing
- 600 WEST 21ST, ANNISTON, AL 36201
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 237990
- SIC code (legacy)
- 1629
- Employees
- 17
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Sep 30, 2008
- Abate by
- Oct 6, 2008
- Penalty
- Initial $4,900 · Current $4,900
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to being crushed: a.On or about June 2, 2008, at 1000 George Douthit Drive SW, Jacksonville, AL, a Dynapac CA 151 vibration roller compactor was operated on a 30-degree grade and was subjected to turn over. Among other methods, one feasible and acceptable method to correct this hazard is: Drive slowly when turning corners. Avoid side hill travel. Operate up and down the slope. Ensure that at least two thirds of the drum width rest on the already compacted ground when driving close to edges or holes. Use special caution when operating on rough or uneven ground. Always maintain a speed consistent with working conditions.
1926.95 A
- Issued
- Sep 30, 2008
- Abate by
- Oct 6, 2008
- Penalty
- Initial $4,900 · Current $4,900
More inspections at Anniston Concrete and Asphalt CO
View Anniston Concrete and Asphalt CO's full OSHA safety record →
More inspections in this industry (NAICS 237990)
More inspections in AL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 312214141.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.