BRAMAN, OK ·
OSHA Inspection: 3 D WELL SERVICE, INC.
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of 3 D WELL SERVICE, INC. in 6 MILES E OF BRAMAN ON BENDER RD; SMITHGRELL 7-4, BRAMAN, OK 74632 (NAICS 213112). OSHA activity number 312379662.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- 3 D WELL SERVICE, INC.
- Site address
- 6 MILES E OF BRAMAN ON BENDER RD; SMITHGRELL 7-4
- City
- BRAMAN
- State
- OK
- ZIP
- 74632
- Mailing
- PO BOX 158, LAMONT, OK 74643
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 213112
- SIC code (legacy)
- 1389
- Employees
- 17
- Ownership type
- Private (A)
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Apr 21, 2009
- Abate by
- Apr 27, 2009
- Penalty
- Initial $750 · Current $450 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm where employees were exposed to falls and struck by hazards: At the worksite: On or about November 20, 2008, and at times prior thereto, the employer required employees to use a well service rig (workover rig) without the rack board guylines connected and tensioned to anchor points. Employees were exposed to the type of hazards associated with failure of the well service rig derrick due to improper guyline support during rig operations. Among others, one feasible and acceptable method of abatement would be to comply with American Petroleum Institute (API) Recommended Practice 54, Recommended Practice for Occupational Safety for Oil and Gas Well Drilling and Servicing Operations.
Recent events (2)
- · I (S) $450.00
- · Z (S) $750.00
5(a)(1)
- Issued
- Apr 21, 2009
- Abate by
- Apr 29, 2009
- Penalty
- Initial $1,500 · Current $900 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm where employees were exposed to fire and fall hazards: At the worksite: On or about November 20, 2008, and at times prior thereto, the employer required employees to perform work from elevated heights of a well service rig derrick without a secondary means of egress properly installed. Employees were exposed to the type of hazards associated with not being able to egress the derrick in the event of an emergency. Among others, one feasible and acceptable method of abatement would be to comply with American Petroleum Institute (API) Recommended Practice 54, Recommended Practice for Occupational Safety for Oil and Gas Well Drilling and Servicing Operations and manufacturer requirements.
Recent events (2)
- · I (S) $900.00
- · Z (S) $1500.00
5(a)(1)
- Issued
- Apr 21, 2009
- Abate by
- Apr 29, 2009
- Penalty
- Initial $1,500 · Current $900 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm due to fall hazards: At the worksite: On or about November 20, 2008, and at times prior thereto, the employer required the use of the well service rig (workover rig) hoist to elevate an employee to various levels above the ground using the equivalent to a boatswain's chair without a lifeline. The employee was exposed to the type of hazards associated with falls from heights. Among others, one feasible and acceptable method of abatement would be to comply with American National Standard (ANSI) ANSI/ASSE A10.22, Safety Requirements for Rope- Guided and Non-Guided Workers' Hoists.
Recent events (2)
- · I (S) $900.00
- · Z (S) $1500.00
1910.132 D01
- Issued
- Apr 21, 2009
- Abate by
- Apr 27, 2009
- Penalty
- Initial $1,500
Recent events (2)
- · I (O)
- · Z (S) $1500.00
More inspections in this industry (NAICS 213112)
More inspections in OK
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 312379662.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.