FAYETTEVILLE, AR —
OSHA Inspection: A & T FRAMING CONTRACTORS, INC. AKA RAZORBACK CONS
Unprogrammed Other inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Other safety inspection of A & T FRAMING CONTRACTORS, INC. AKA RAZORBACK CONS in 674 SOUTH ROYAL OAK PARKWAY, FAYETTEVILLE, AR 72701 (NAICS 238130). OSHA activity number 312541758.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- A & T FRAMING CONTRACTORS, INC. AKA RAZORBACK CONS
- Site address
- 674 SOUTH ROYAL OAK PARKWAY
- City
- FAYETTEVILLE
- State
- AR
- ZIP
- 72701
- Mailing
- 8205 CAMP BOWIE BLVD. WEST, STE 102, FORT WORTH, TX 76116
What kind of inspection was it?
- Inspection type
- Unprogrammed Other (I)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- SIC code (legacy)
- 1751
- Employees
- 11
- Ownership type
- A
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Jan 20, 2009
- Abate by
- Jan 23, 2009
- Penalty
- Initial $875 · Current $875
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of falls from elevation: At the job site, located at 674 South Royal Oak Parkway, Fayetteville, Arkansas, employees were using wooden two job-made ladders without the filler blocks inserted between the rungs to support the cleats nor were the rungs recessed, exposing the employees to the hazards of falls from elevation. Among other methods, one feasible and acceptable abatement method to correct this hazard is to conform to the American National Standards Institute (ANSI) A14.4.4.4- 1968 which states: "Wood cleats shall be inset into side rails not less than 1/2 inch or shall be attached directly to the edge of the side rails, in which case filler blocks of the thickness of the cleats shall be securely attached to the edge of the rail for the full length between cleats, or equivalent construction"
1926.25 A
- Issued
- Jan 20, 2009
- Abate by
- Jan 30, 2009
- Penalty
- Initial $700 · Current $700
1926.501 B13
- Issued
- Jan 20, 2009
- Abate by
- Jan 23, 2009
- Penalty
- Initial $3,000 · Current $3,000
1926.1053 B01
- Issued
- Jan 20, 2009
- Abate by
- Jan 23, 2009
- Penalty
- Initial $3,000 · Current $3,000
More inspections in this industry (NAICS 238130)
More inspections in AR
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 312541758.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.