Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,196,249Inspections Most recent open 2026-08-20 Last loaded 2026-08-24

OSHA Inspection: SCANDRILL, INC.

Accident-driven inspection · Safety discipline

On , OSHA opened an accident-driven safety inspection of SCANDRILL, INC. in 205 HALL RD, LOGANSPORT, LA 71049 (NAICS 213111). OSHA activity number 313026486.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Scandrill, INC. for free Get an email when a new federal OSHA severe-injury report for Scandrill, INC. is published. One employer, no account, unsubscribe in one click.
Establishment
SCANDRILL, INC.
Site address
205 HALL RD
City
LOGANSPORT
State
LA
ZIP
71049
Mailing
11777 KATY FREEWAY, SUITE 470, HOUSTON, TX 77079
Inspection type
Accident-driven (A)
Scope
Partial (B)
Discipline
Safety
Advance notice
Yes
Union status
Non-union (N)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
213111
SIC code (legacy)
1381
Employees
11
Ownership type
Private (A)

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 6 exposed
Issued
Feb 3, 2010
Abate by
Feb 16, 2010
Penalty
Initial $4,500 · Current $2,700 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish to each of his employees a place of employment which was free from
recognized hazards
that were causing or likely to cause death or serious physical harm to
employees in that
employees were exposed to the hazard of being struck by drill pipe:
On or about 15 Sep 09, the employer did not ensure that there was adequate
communications
between personnel on the "monkey" board and the driller located at the
controls on the drill
floor, to alert the driller about potential hazards observed from above
the drill floor. This
exposed employees on the drill floor to being struck by unsecured drill
pipe.
Among other methods, one feasible and acceptable abatement method to
correct this hazard
would be to: install a communication system between the drill floor and
the monkey boards that
would allow derrickhands to notify the driller that drill pipe was hung up
under one of the beams
in the derrick and to stop lifting the pipe.
DISCLAIMERS:
1)You are not limited to the abatement methods suggested above.
2)The methods explained are general and may not be effective in all cases.
3)   The employer is responsible for selecting and carrying out an
appropriate method.
Recent events (2)
  • · I (S) $2700.00
  • · Z (S) $4500.00

View Scandrill, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 313026486.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.