Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: RND CONSTRUCTION COMPANY

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of RND CONSTRUCTION COMPANY in 18700 US 23, CIRCLEVILLE, OH 43113 (NAICS 238350). OSHA activity number 313149015.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch RND Construction Company — free Get an email when a new federal OSHA severe-injury report for RND Construction Company is published. One employer, no account, unsubscribe in one click.
Site address
18700 US 23
City
CIRCLEVILLE
State
OH
ZIP
43113
Mailing
6840 SPARROW LANE, COLUMBUS, OH 43235
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238350
SIC code (legacy)
1751
Employees
3
Ownership type
A

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 03 1 instance 1 exposed
Issued
Jun 30, 2009
Abate by
Jul 10, 2009
Penalty
Initial $750 · Current $750
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not furnish employment
and a place of employment which were free from recognized hazards that
were causing or likely to cause
death or serious physical harm to employees in that employees were exposed
to:
a.  On or about June 4, 2009, at the above addressed jobsite, an employee
was observed standing on the
edges of the skid steer bucket in order to reach the soffet of the roof.
The employee was installing
flashing on the soffett.  The employee was also observed riding in the
bucket when the skid steer was
moved.  Employee was exposed to a 12 foot fall to the ground.  No means of
fall protection was
utilized.  The Association of Equipment Manufacturers (AEM) recognizes
this practice as a hazard as
does the Manufacturer of the skid steer.  The employer stated that he had
a scissor lift on the site,
however, due to the terrain being unlevel, it was difficult to use because
it would shut off when it
reached each location for the flashing trim to be installed.  A safer
means of pulling the scissor lift
straight in instead of sideways was discussed or the use of a ladder to
install the trim.

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 313149015.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.