KINSTON, NC —
OSHA Inspection: COASTAL WHOLESALE, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of COASTAL WHOLESALE, INC. in 412 PARK AVE, KINSTON, NC 28501 (NAICS 424410). OSHA activity number 313215121.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- COASTAL WHOLESALE, INC.
- Site address
- 412 PARK AVE
- City
- KINSTON
- State
- NC
- ZIP
- 28501
- Mailing
- PO BOX 1375, KINSTON, NC 28503
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 424410
- SIC code (legacy)
- 5141
- Employees
- 102
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
6 citations on file for this inspection.
95012901
- Issued
- May 26, 2009
- Abate by
- May 29, 2009
- Penalty
- Initial $1,400 · Current $1,400
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish each of his employees conditions of employment and a place of employment free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to throw against, struck by and crushed by Roll Over Protection System (ROPS) hazard during tip-over: a)facility - an employee was observed operating a Crown Forklift (Model SC) without wearing the installed seat belt during operation. One feasible and acceptable abatement method, among others, to correct this hazard is to have operators fasten the seat belt while operating equipment. (Reference: ASME B56-1-1993, Paragraph5.3.19: An active operator protection device or system, when provided, shall be used.)
1910.212 A03 II
- Issued
- May 26, 2009
- Abate by
- May 29, 2009
- Penalty
- Initial $500 · Current $500
1910.219 D01
- Issued
- May 26, 2009
- Abate by
- May 29, 2009
- Penalty
- Initial $500 · Current $500
1910.219 E03 I
- Issued
- May 26, 2009
- Abate by
- May 29, 2009
1910.1200 E01
- Issued
- May 26, 2009
- Abate by
- Jul 13, 2009
1910.1200 E01 I
- Issued
- May 26, 2009
- Abate by
- Jul 13, 2009
More inspections in this industry (NAICS 424410)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 313215121.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.