TIOGA, PA —
OSHA Inspection: ATLAS OIL FIELD CONSTRUCTION
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of ATLAS OIL FIELD CONSTRUCTION in 1724 ROUTE 287, TIOGA, PA 16946 (NAICS 811310). OSHA activity number 314162108.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ATLAS OIL FIELD CONSTRUCTION
- Site address
- 1724 ROUTE 287
- City
- TIOGA
- State
- PA
- ZIP
- 16946
- Mailing
- PO BOX 467, MANSFIELD, PA 16933
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 811310
- SIC code (legacy)
- 7692
- Employees
- 5
- Ownership type
- A
Citations
15 citations on file for this inspection.
5(a)(1)
- Issued
- May 13, 2011
- Abate by
- Jun 6, 2011
- Penalty
- Initial $5,000 · Current $5,000
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of being pinned and crushed: a) In the shop area: The Nissan model 90 forklift was allowed to be used without a seat belt, exposing the operator to the hazard of being pinned and crushed by the overhead guard in the event of a rollover accident, observed on or about March 25, 2011. ABATEMENT CERTIFICATION REQUIRED ABATEMENT NOTE: Among other methods, one feasible and acceptable abatement method to correct this hazard is to: a) Follow the manufacturer's instructions in the operator's manual for use of the seatbelt. b) Follow the safety standards published on page 10, section 5.3.19 of ANSI/ITSDF B56.1-2005 Safety Standards for Low Lift and High Lift Trucks which states that "an active operator protective device when provided, shall be used". c) Instruct each operator of the requirements to always use the seatbelt when operating a forklift.
1910.106 H08 I
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
- Penalty
- Initial $5,000 · Current $1,000 Reduced
Recent events (2)
- — I (O) $1000.00
- — Z (S) $5000.00
1910.36 B01
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
- Penalty
- Initial $4,000 · Current $4,000
Recent events (2)
- — I (O) $4000.00
- — Z (S) $4000.00
1910.37 B02
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
Recent events (2)
- — I (O)
- — Z (S)
1910.37 B05
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
Recent events (2)
- — I (O)
- — Z (S)
1910.252 A02 XV
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
- Penalty
- Initial $4,000 · Current $2,000 Reduced
Recent events (2)
- — I (O) $2000.00
- — Z (S) $4000.00
1910.253 B04 III
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
- Penalty
- Initial $4,000 · Current $2,000 Reduced
Recent events (2)
- — I (O) $2000.00
- — Z (S) $4000.00
1910.253 B02 IV
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
Recent events (2)
- — I (O)
- — Z (S)
1910.215 A01
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
- Penalty
- Initial $4,000 · Current $3,000 Reduced
Recent events (2)
- — I (O) $3000.00
- — Z (S) $4000.00
1910.243 C01
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
Recent events (2)
- — I (O)
- — Z (S)
1910.305 B01
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
- Penalty
- Initial $5,000 · Current $5,000
Recent events (2)
- — I (S) $5000.00
- — Z (S) $5000.00
1910.305 B02
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
- Penalty
- Current $3,000
Recent events (2)
- — I (O) $3000.00
- — Z (S)
1910.305 G01 IVC
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
Recent events (2)
- — I (O)
- — Z (S)
1910.303 B02
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
Recent events (2)
- — I (S)
- — Z (S)
1910.1200 G01
- Issued
- May 2, 2011
- Abate by
- Jun 6, 2011
Recent events (2)
- — I (O)
- — Z (O)
More inspections at Atlas OIL Field Construction
View Atlas OIL Field Construction's full OSHA safety record →
More inspections in this industry (NAICS 811310)
More inspections in PA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 314162108.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.