SAN ANTONIO, TX —
OSHA Inspection: T.P.I. LLC
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of T.P.I. LLC in BARLITE AND NAVAJO, SAN ANTONIO, TX 78224 (NAICS 237110). OSHA activity number 314304924.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- T.P.I. LLC
- Site address
- BARLITE AND NAVAJO
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78224
- Mailing
- 4111 FACTORY HILL, SAN ANTONIO, TX 78219
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 237110
- SIC code (legacy)
- 1623
- Employees
- 11
- Ownership type
- A
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Apr 18, 2011
- Abate by
- Apr 21, 2011
- Penalty
- Initial $4,200 · Current $4,200
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment wich were free from recognized hazards that were likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of potentially hazardous atmosphere: a)On or about 12/20/2010, at the work site, the employees were exposed to potential hazardous atmosphere while entering a 35 foot deep tunnel a permit required confined space. Sperian Biosystems multipro meters, SN 64815 and 63642, and Sperian Cannonball 3 atmospheric monitor SN 05477 were not calibrated or verification of accuracy were not done daily. One feasible method of abatement is to obtain a span gas calibration test kit and to perform daily checks on any equipment to test each sensor used to verify the accuracy of the calibration as recommended by the manufacturer. Ensure all equipment used is calibrated annually by the manufacturer or approved servicing company.
1926.21 B06 I
- Issued
- Apr 18, 2011
- Abate by
- Apr 28, 2011
- Penalty
- Initial $4,200 · Current $4,200
1926.800 J01 IA
- Issued
- Apr 18, 2011
- Abate by
- Apr 28, 2011
1926.800 J03
- Issued
- Apr 18, 2011
- Abate by
- Apr 28, 2011
More inspections at T.P.I. LLC
View T.P.I. LLC's full OSHA safety record →
More inspections in this industry (NAICS 237110)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 314304924.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.