OSHA Inspection: ILLINOIS MOLD BUILDERS, INC. DBA DYNASTY MOLD BUIL

Issued

Jun 2, 2010

Abate by

Jun 21, 2010

Penalty

Initial $600 · Current $300 Reduced

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to a laceration hazard:
a) Grinding Room- The graphite cutting saw, such as the Reliant Vertical
Bandsaw, Serial
#1019140, was not equipped with a mechanism to prevent the machines from
automatically
restarting upon restoration of power after a power failure.
Among other methods, one feasible and acceptable method to correct this
hazard is to
include, but not be limited to the following:
1) Provide a magnetic restarter or similar device as required by the
American National
Standards Institute (ANSI) B11.10-2003, Section 6.11, that in the event of
an interruption
in the electrical supply the device would prevent the saw from restarting
automatically
when power is restored.
In accordance with 29 CFR 1903.19(d), abatement certification is required
for this violation
(using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in
addition, documentation that abatement is complete must be included with
your
certification.  This documentation may include, but is not limited to,
evidence of the
purchase or repair of the equipment, photographic or video evidence of
abatement, or other
written records.

Issued

Jun 2, 2010

Abate by

Aug 5, 2010

Penalty

Initial $1,500 · Current $750 Reduced

Issued

Jun 2, 2010

Abate by

Jul 5, 2010

Penalty

Initial $1,500 · Current $750 Reduced

Issued

Jun 2, 2010

Abate by

Jun 21, 2010

Penalty

Initial $750 · Current $375 Reduced

Issued

Jun 2, 2010

Abate by

Jun 21, 2010

Penalty

Initial $600 · Current $300 Reduced