BISMARCK, ND ·
OSHA Inspection: FAA TOWER BISMARCK
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of FAA TOWER BISMARCK in 2301 UNIVERSITY DRIVE, BISMARCK, ND 58504 (NAICS 922190). OSHA activity number 314777848.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- FAA TOWER BISMARCK
- Site address
- 2301 UNIVERSITY DRIVE
- City
- BISMARCK
- State
- ND
- ZIP
- 58504
- Mailing
- 2301 UNIVERSITY DRIVE, BISMARCK, ND 58504
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Union (Y)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 922190
- SIC code (legacy)
- 9229
- Employees
- 26
- Ownership type
- Federal government (D)
Citations
3 citations on file for this inspection.
1960.8 B
- Issued
- Mar 10, 2011
- Abate by
- Apr 12, 2011
General-duty citation text
29 CFR 1960.8(b): The agency shall comply with the Occupational Safety and Health Administration standards applicable to the agency: (a) For the employees exposed to fire hazards from "exit routes" that were not protected with a two-hour fire rating. The interior walls of both HVAC service rooms had large unsealed holes cut in them that negated the fire resistance of the wall to protect the employees within. (b) For the employees exposed to fire hazards from "exit routes" that were not protected with a two-hour fire rating. The interior wall of the electrical/computer service room had large holes cut in them that negated the fire resistance of the wall to protect the employees within. References: (1) 29 CFR 1910.36(a)(2): An exit must be separated by fire resistant materials. Construction materials used to separate an exit from other parts of the workplace must have a one-hour fire-resistance rating if the exit connects three or fewer stories and a two-hour fire-resistance rating if the exit connects four or more stories. (2) The Alternative Standard for Fire Safety in Airport Traffic Control Towers, paragraph C.3.i. "Alternative A. For each ATCT having a single exit route and total occupant load of less that twenty-five occupants, the following requirements must be met:" and its sub paragraph B. "The tower is of Type I, Type II, or Type IV construction". Abatement Note: Abatement certification is required for this item (see enclosed "Sample Abatement Certification Letter").tion
1960.8 B
- Issued
- Mar 10, 2011
- Abate by
- Apr 12, 2011
General-duty citation text
29 CFR 1960.8(b): The agency shall comply with the Occupational Safety and Health Administration standards applicable to the agency: (a) For the employees exposed to fire hazards from "exit routes" that were not equipped with functioning emergency lighting to assist employees in the evacuation of the tower in periods of limited to no visibility. The hallways and the stairwell emergency lights did not have a functioning secondary battery supply in the event that power was lost to the facility. References: (1) 29 CFR 1910.37(a)(4): Safeguards designed to protect employees during an emergency (e.g. sprinkler systems, alarm systems, fire doors, exit lighting) must be in proper working order at all times. (2) NFPA 101 Life Safety Code section 7.9.2.1 "Emergency illumination shall be provided for not less than 1 1/2 hours in the event of failure of normal lighting. Emergency lighting facilities shall be arranged to provide initial illumination that is no less than an average of 1 ft-candle (10 lux) and, at any point, not less than 0.1 ft- candle (1 lux), measured along the path of the egress at floor level." Abatement Note: Abatement certification is required for this item (see enclosed "Sample Abatement Certification Letter").tion
1960.8 B
- Issued
- Mar 10, 2011
- Abate by
- Apr 12, 2011
General-duty citation text
29 CFR 1960.8(b): The agency shall comply with the Occupational Safety and Health Administration standards applicable to the agency: (a) For the employees exposed to electrical shock hazards from an inadequate grounding system next to water. In the control tower a water fountain was plugged into a standard outlet that was not GFCI protected either in the circuit or the plug itself. References: 29 CFR 1910.303(b)(1): Examination of electric equipment shall be free from recognized hazards that are likely to cause death or serious physical harm to employees. Abatement Note: Abatement certification is required for this item (see enclosed "Sample Abatement Certification Letter").tion
More inspections in this industry (NAICS 922190)
More inspections in ND
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 314777848.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.