PHENIX CITY, AL —
OSHA Inspection: HAMMETT STEEL LLC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of HAMMETT STEEL LLC. in 3015 LAKEWOOD DRIVE, PHENIX CITY, AL 36867 (NAICS 332312). OSHA activity number 315194738.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- HAMMETT STEEL LLC.
- Site address
- 3015 LAKEWOOD DRIVE
- City
- PHENIX CITY
- State
- AL
- ZIP
- 36867
- Mailing
- PO BOX 1873, PHENIX CITY, AL 36867
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 332312
- SIC code (legacy)
- 3441
- Employees
- 17
- Ownership type
- A
Citations
19 citations on file for this inspection.
5(a)(1)
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
- Penalty
- Initial $2,400 · Current $1,440 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to crush hazards while using 2 ton overhead hoist with broken / missing safety latches to move materials around the shop: a)3015 Lakewood Drive, Phenix City, AL 36867; On or about March 3, 2011 and at times prior thereto employees were exposed to crush hazards while using a 2 ton Budget overhead hoist with a broken / missing safety latch on the hoist hook in bay one to move material around the shop. The employer failed to ensure frequent inspections had been performed by an operator or other designated person of the hoist for missing or defective equipment. A feasible and acceptable method to correct this hazard is to conduct frequent inspections during operation of the hoist for missing or defective equipment in accordance with ASME B30.10-1999, Hooks and ASME B30.16.-1998, Overhead Hoists. 2. Repair or replace the safety latches and ensure they meet the requirement of the manufacturer's operator manual, ASME B30.10-1999, Hooks, and ASME B30.16.-1998, Overhead Hoists. b)3015 Lakewood Drive, Phenix City, AL 36867; On or about March 3, 2011 and at times prior thereto employees were exposed to crush hazards while using a 2 ton Budget overhead hoist with a broken / missing safety latch on the hoist hook in bay two paint area to move material around the shop. The employer failed to ensure frequent inspections had been performed by an operator or other designated person of the hoist for missing or defective equipment. A feasible and acceptable method to correct this hazard is to conduct frequent inspections during operation of the hoist for missing or defective equipment in accordance with ASME B30.10-1999, Hooks and ASME B30.16.-1998, Overhead Hoists. 2. Repair or replace the safety latches and ensure they meet the requirement of the manufacturer's operator manual, ASME B30.10-1999, Hooks, and ASME B30.16.-1998, Overhead Hoists.d
Recent events (2)
- — I (S) $1440.00
- — Z (S) $2400.00
5(a)(1)
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
- Penalty
- Initial $1,800 · Current $1,080 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of being struck by fragments of Polyvinyl Chloride (PVC) plastic pipe in the event that the PVC plastic pipe ruptured: a)3015 Lakewood Drive, Phenix City, AL 36867; On or about March 3, 2011 and at times prior thereto the employer exposed his employees to the hazard of being struck by fragments of Polyvinyl Chloride (PVC) plastic pipe in the event that the PVC plastic pipe ruptured. PVC plastic piping was used in exposed above ground locations in the Shop Areas to transport compressed air at 115 psi. Among other methods, two feasible and acceptable abatement methods to correct this hazard are #1) Replace PVC piping and fittings with metal piping and fittings, which are rated to transport compressed air in exposed above ground locations and #2) Replace PVC piping and fittings with Acrylonitrile-Butadiene Styrene (ABS) pipes and fittings, which are shatter resistant and manufactured for above ground use of compressed air. The prohibited use of PVC is referenced in ASME Gas Transmission and Distribution Piping Systems USAS B31.8-1986, Section 842.43, which prohibits the above ground use of PVC pipe for compressed air conveyance.
Recent events (2)
- — I (S) $1080.00
- — Z (S) $1800.00
1910.215 A04
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
- Penalty
- Initial $2,400 · Current $1,440 Reduced
Recent events (2)
- — I (S) $1440.00
- — Z (S) $2400.00
1910.215 B09
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
1910.243 C01
- Issued
- Mar 30, 2011
- Abate by
- Mar 3, 2011
- Penalty
- Initial $1,530 · Current $918 Reduced
Recent events (2)
- — I (S) $918.00
- — Z (S) $1530.00
1910.303 G01
- Issued
- Mar 30, 2011
- Abate by
- Apr 8, 2011
- Penalty
- Initial $1,800 · Current $1,080 Reduced
Recent events (2)
- — I (S) $1080.00
- — Z (S) $1800.00
1910.305 B01 I
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
- Penalty
- Initial $3,000 · Current $1,800 Reduced
Recent events (2)
- — I (S) $1800.00
- — Z (S) $3000.00
1910.305 G01 IVA
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
1910.305 G01 IIID
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
1910.305 J02 I
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
1910.305 B01 II
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
- Penalty
- Initial $3,000 · Current $1,800 Reduced
Recent events (2)
- — I (S) $1800.00
- — Z (S) $3000.00
1910.1200 E01
- Issued
- Mar 30, 2011
- Abate by
- Apr 26, 2011
- Penalty
- Initial $1,800 · Current $1,080 Reduced
Recent events (2)
- — I (S) $1080.00
- — Z (S) $1800.00
1910.1200 H01
- Issued
- Mar 30, 2011
- Abate by
- Apr 26, 2011
1904.29 B01
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
- Penalty
- Initial $600 · Current $360 Reduced
Recent events (2)
- — I (O) $360.00
- — Z (O) $600.00
1904.32 A02
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
- Penalty
- Initial $600 · Current $360 Reduced
Recent events (2)
- — I (O) $360.00
- — Z (O) $600.00
1910.134 C01
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
1910.134 E01
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
1910.134 F02
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
1910.134 G01 IA
- Issued
- Mar 30, 2011
- Abate by
- Apr 12, 2011
More inspections at Hammett Steel LLC.
View Hammett Steel LLC.'s full OSHA safety record →
More inspections in this industry (NAICS 332312)
More inspections in AL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 315194738.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.