Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,549Inspections Most recent open 2026-08-27 Last loaded 2026-08-31

OSHA Inspection: VEGAS AUTO SALON

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of VEGAS AUTO SALON in 4500 SOUTH ARVILLE STREET, LAS VEGAS, NV 89103 (NAICS 811198). OSHA activity number 316000074.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Vegas Auto Salon for free Get an email when a new federal OSHA severe-injury report for Vegas Auto Salon is published. One employer, no account, unsubscribe in one click.
Establishment
VEGAS AUTO SALON
Site address
4500 SOUTH ARVILLE STREET
City
LAS VEGAS
State
NV
ZIP
89103
Mailing
4500 SOUTH ARVILLE STREET, LAS VEGAS, NV 89103
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (N)
Opened
Closing conference
Last modified
Data loaded
NAICS code
811198
SIC code (legacy)
7549
Employees
1
Ownership type
Private (A)
Industry flags
Manufacturing safety.

1 citation on file for this inspection.

618037501

Serious Gravity 05 2 instances 1 exposed
Issued
May 14, 2012
Abate by
May 19, 2012
Penalty
Initial $3,000 · Current $3,000
Nevada Revised Statute 618.375(1): Duties of employers. Every employer
shall furnish
employment and a place of employment which are free from recognized
hazards that are causing
or are likely to cause death or serious physical harm to his or her
employees.
At the west garage of Vegas Auto Salon workplace, an employee was using two
hydraulic automotive lifts to raise vehicles above the ground while
performing work, and
was not protected from crushing hazards while using either lift. Both of
the lifts were
missing all four stop bolts and all four restraint bars. These safety
features are necessary
to prevent movement by the support arms by which vehicles are suspended.
One feasible and acceptable means of abatement is to follow the
requirements of
ANSI/ALI ALOIM-2000, and ensure that both lifts are inspected and
certified for use
at least annually by a qualified person.
Reference: American National Standards Institute (ANSI): ANSI/ALI ALOIM-
2000: Safety Requirements for Operation, Inspection and Maintenance:
- Paragraph 4.4.4 (Operator Responsibilities): The lift owner or employer
shall take all appropriate steps to follow the recommended inspection
procedures of the lift manufacturer, but in no event shall the lift
operator
fail to inspect or take notice of the following features on a daily basis:
(1) Accessibility and readability of the operating procedures, safety
tips and generic safety material;
(2) Accessibility and readability of safety warning labels;
(3) Readability of the rated load capacity of the lift;
(4) Proper operation of the lift controls, restraints and locking
devices.
- Paragraph 5.5: Qualified Inspection Frequency. Inspections by the owner
or employer shall follow the recommendations of the lift manufacturer as
to frequency. Without regard to the frequency of inspection specified by
the lift manufacturer, whether it be weekly, monthly, semi-annually,
annually or on some other basis, the owner or employer shall ensure that
the points presented in 5.6 are inspected by a qualified lift inspector as
a
minimum annual requirement.
- Paragraph 6.2.1: Repair Maintenance Procedure. The owner or
employer shall perform repair maintenance procedures whenever they are
called for by the lift operator, qualified lift inspector or preventive
maintenance technician. Repair maintenance shall be performed in
accordance with the recommendations of the lift manufacturer in order to
ensure reliability and allow the continued safe operation of the lift.
Recent events (2)
  • · Y (S) $3000.00
  • · Z (S) $3000.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 316000074.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.