FAYETTEVILLE, NC —
OSHA Inspection: HUGO SANCHEZ ALBA DBA HUGO SANCHEZ SIDING
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of HUGO SANCHEZ ALBA DBA HUGO SANCHEZ SIDING in 3050 PLANTATION GARDEN WY., BLD #2, FAYETTEVILLE, NC 28303 (NAICS 238170). OSHA activity number 316598705.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- HUGO SANCHEZ ALBA DBA HUGO SANCHEZ SIDING
- Site address
- 3050 PLANTATION GARDEN WY., BLD #2
- City
- FAYETTEVILLE
- State
- NC
- ZIP
- 28303
- Mailing
- 4409 JARVIS RD., GREENSBORO, NC 27407
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238170
- SIC code (legacy)
- 1761
- Employees
- 6
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
4 citations on file for this inspection.
95012901
- Issued
- Oct 23, 2012
- Abate by
- Nov 16, 2012
- Penalty
- Initial $2,100 · Current $2,100
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees conditions of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees, in that an employee was exposed to fall hazards. a)3050 Plantation Garden Wy., Bld #2 - where an employee at approximately 27-feet above muddy earth was installing fascia and soffit vinyl from a commercially designed and constructed metal work platform mounted to the forks of an XTREME XRM842 telescopic rough terrain forklift without an operator in the operator's position. Abatement note: Among others, one reasonable and feasible method of abatement would be to ensure an operator was in place to control the position of the platform. b)3050 Plantation Garden Wy., Bld #2 - where an employee was installing fascia and soffit vinyl from a commercially designed and constructed metal work platform mounted to the forks of an XTREME XRM842 telescopic rough terrain forklift climbed over the guard rails of the platform from the elevated position at approximately 27-feet above muddy earth. Abatement note: Among others, one reasonable and feasible method of abatement would be to ensure the installer was trained to enter and exit the personnel platform from the ground level only. Reference: ASME B56.6-1992, Paragraph 5.15.1, "A rough terrain forklift truck should not be used to lift people unless there is no other practical option. If a rough terrain forklift truck must be used to lift people, the following precautions for the protection of personnel shall be taken: (s) A trained operator must be in position to control the rough terrain forklift truck or available to operate controls if the platform is not equipped with controls. (u) Personnel are to maintain firm footing on the platform floor unless secured by body belt and lanyard. Use of railings, planks, ladders, etc.,on the platform for the purpose of achieving additional reach or height is prohibited. (w) Platform shall be lowered to floor level for personnel to enter and exit. Personnel shall not climb on any part of the rough terrain forklift truck in attempting to enter or exit."
1910.178 L04 IIA
- Issued
- Oct 23, 2012
- Abate by
- Nov 16, 2012
- Penalty
- Initial $2,100 · Current $2,100
1926.453 B02 V
- Issued
- Oct 23, 2012
- Abate by
- Oct 26, 2012
- Penalty
- Initial $1,500 · Current $1,500
1926.1060 A01 III
- Issued
- Oct 23, 2012
- Abate by
- Nov 16, 2012
- Penalty
- Initial $2,100 · Current $2,100
More inspections in this industry (NAICS 238170)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 316598705.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.