ASHEVILLE, NC —
OSHA Inspection: ASHEVILLE PAINT & POWDER COAT, INC.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of ASHEVILLE PAINT & POWDER COAT, INC. in 16 OLD CHARLOTTE HIGHWAY, ASHEVILLE, NC 28803 (NAICS 332812). OSHA activity number 316741164.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ASHEVILLE PAINT & POWDER COAT, INC.
- Site address
- 16 OLD CHARLOTTE HIGHWAY
- City
- ASHEVILLE
- State
- NC
- ZIP
- 28803
- Mailing
- 123 LYMAN STREET, ASHEVILLE, NC 28801
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 332812
- SIC code (legacy)
- 3479
- Employees
- 14
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
6 citations on file for this inspection.
95012901
- Issued
- Feb 4, 2013
- Abate by
- Mar 21, 2013
- Penalty
- Initial $150 · Current $98 Reduced
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees conditions of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death of serious physical harm to employees in that employees were exposed to the potential hazard of struck-by injuries from dropped loads resulting from a malfunctioning manual chain hoist: a)Dotson Building - - Sandblasting Room: The employer failed to develop and implement a process to ensure frequent and periodic inspections of the overhead manual chain hoists. Among other methods, one applicable and feasible method to correct this hazard is to implement a schedule of frequent and periodic inspections of the overhead manual chain hoists that complies with the requirements outlined in ANSI B30.16-2003 "Overhead Hoists (Underhung); Chapter 16-2: Inspection, Testing, and Maintenance; Section 16-2.1.1(b)(1) Frequent Inspections, Section 16-2.1.1(b)(12) Periodic Inspections, and Chapter 16-2 Table 1.ble
Recent events (2)
- — I (S) $97.50
- — Z (S) $150.00
95012901
- Issued
- Feb 4, 2013
- Abate by
- Mar 21, 2013
- Penalty
- Initial $150 · Current $98 Reduced
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees conditions of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death of serious physical harm to employees in that employees were exposed to the potential hazard of struck-by injuries from dropped loads due to an over-loaded manual chain hoist: a)Dotson Building - - Sandblasting Room: The employer failed to ensure the rated load capacity markings on two overhead CM 2-ton manual chain hoists were legible from the floor by employees operating the chain hoists. Among other methods, one applicable and feasible method to correct this hazard is to apply and maintain clear markings on the casings of the overhead chain hoists or the hoists' load blocks which display the rated load capacity of the hoists and are legible from the floor.e
Recent events (2)
- — I (S) $97.50
- — Z (S) $150.00
95012901
- Issued
- Feb 4, 2013
- Abate by
- Mar 21, 2013
- Penalty
- Initial $150 · Current $98 Reduced
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees conditions of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death of serious physical harm to employees in that employees were exposed to the potential hazard of struck-by injuries resulting from the improper operation of manual chain hoists: a)Facility - - Dotson Building - - Sandblasting Room: The employer failed to ensure labels displaying instructions detailing operational warnings were affixed to two overhead CM manual chain hoists or their load blocks. Among other methods, one applicable and feasible method to correct this hazard is to obtain and affix to the chain hoist or its' load block a label displaying the operational warnings contained in ANSI B30.16-2003 "Overhead Hoists (Underhung); Chapter 16-1 - Marking, Construction, and Installation; Section 16-1.1.4 - Warnings.
Recent events (2)
- — I (S) $97.50
- — Z (S) $150.00
1910.24 B
- Issued
- Feb 4, 2013
- Abate by
- Mar 21, 2013
- Penalty
- Initial $300 · Current $195 Reduced
Recent events (2)
- — I (S) $195.00
- — Z (S) $300.00
1910.132 A
- Issued
- Feb 4, 2013
- Abate by
- Mar 21, 2013
- Penalty
- Initial $500 · Current $325 Reduced
Recent events (2)
- — I (S) $325.00
- — Z (S) $500.00
1910.178 L06
- Issued
- Feb 4, 2013
- Abate by
- Mar 21, 2013
More inspections at Asheville Paint & Powder Coat, INC.
View Asheville Paint & Powder Coat, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 332812)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 316741164.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.