CARRBORO, NC ·
OSHA Inspection: EMC AUTO REPAIR, LLC DBA MEINEKE CAR CARE
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of EMC AUTO REPAIR, LLC DBA MEINEKE CAR CARE in 407 E MAIN STREET, CARRBORO, NC 27510 (NAICS 811111). OSHA activity number 317356525.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- EMC AUTO REPAIR, LLC DBA MEINEKE CAR CARE
- Site address
- 407 E MAIN STREET
- City
- CARRBORO
- State
- NC
- ZIP
- 27510
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 811111
- SIC code (legacy)
- 7538
- Employees
- 7
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
5 citations on file for this inspection.
95012901
- Issued
- Jan 13, 2014
- Abate by
- Jan 16, 2014
- Penalty
- Initial $3,500 · Current $2,450 Reduced
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish each of his employees conditions of employment and a place of employment free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to a crushed by hazard. a)Service Area: where a Challenger (Model CL10V3, 10,000 lbs, 230V, 60Hz, 18A) automotive lift was observed to be missing bolts on the extender arms and it and the other lifts in the service area including, but not limited to, ALM (Model 9002), Hunter (Model RX12), Tuxedo (Model TP11), Challenger (Model E10), and Ben Pearson (Model B9000A) automotive lifts and the employer could not verify that periodic qualified inspections of the lifts had been conducted. Reference: ANSI/ALI 2008 Standard for Automotive Lifts - Safety Requirements for Operation, Inspection and Maintenance. Section 5: Periodic Qualified Inspection - 5.1 "The owner or employer shall establish a periodic inspection procedure in accordance with the recommendations of the lift manufacturer in order to ensure reliability and allow the continued safe operation of the lift." 5.6.2 Inspection Points - All Lifts: 5.6.2.12 "On lifts using swing arms, check to ensure that arm telescoping stops are functioning as intended. Report improper function or excessive wear. Challenger Lifts Installation, Operation and Maintenance Manual Model CL10 - Page 12 - Maintenance "The following maintenance points are suggested as the basis of a routine maintenance program. The actual maintenance program should be tailored to the installation. See ANSI/ALI ALOIM booklet for periodic inspection checklist and maintenance log sheet. (Daily) "Check for loose or broken parts." One feasible and acceptable method of abatement is for the employer to periodically retain a qualified lift inspection to conduct and document a periodic qualified inspection of each automotive lift.otive
Recent events (2)
- · I (S) $2450.00
- · Z (S) $3500.00
1910.212 B
- Issued
- Jan 13, 2014
- Abate by
- Jan 16, 2014
- Penalty
- Initial $600 · Current $420 Reduced
Recent events (2)
- · I (S) $420.00
- · Z (S) $600.00
1910.215 A04
- Issued
- Jan 13, 2014
- Abate by
- Jan 16, 2014
- Penalty
- Initial $600 · Current $420 Reduced
Recent events (2)
- · I (S) $420.00
- · Z (S) $600.00
1910.1200 E01 I
- Issued
- Jan 13, 2014
- Abate by
- Jan 15, 2014
Recent events (2)
- · I (O)
- · Z (O)
1910.1200 G01
- Issued
- Jan 13, 2014
- Abate by
- Jan 16, 2014
More inspections in this industry (NAICS 811111)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 317356525.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.