Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: SNIDER BROTHERS LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of SNIDER BROTHERS LLC in 8899 EAST PRENTICE AVENUE, ENGLEWOOD, CO 80111 (NAICS 541320). OSHA activity number 330290883.

Watch Snider Brothers LLC — free Get an email when a new federal OSHA severe-injury report for Snider Brothers LLC is published. One employer, no account, unsubscribe in one click.
Establishment
SNIDER BROTHERS LLC
Site address
8899 EAST PRENTICE AVENUE
City
ENGLEWOOD
State
CO
ZIP
80111
Mailing
18126 E. BEAVER AVENUE, AURORA, CO 80016
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
541320
Employees
4
Ownership type
A

2 citations on file for this inspection.

5(a)(1)

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $2550.00 · Current $750.00 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The employer did not furnish employment and a place of employment which was free from recognized hazards which were likely to cause death or serious physical harm to employees in that, employees were exposed to fall hazards:    a)  On or about March 25, 2011, and at times prior, employees were not adequately restrained from catapulting from the basket or an aerial lift through the use of a properly installed fall restraint system.  An employee was utilizing a fall arrest system with a 6 foot lanyard and a body belt while working in the basket which would not provide adequate protection.  The aerial lift was moving over and working on uneven ground.     b)  On or about March 25, 2011, and at times prior, employees used a body belt as part of a fall arrest system while working from an aerial lift.  The use of a body belt was not acceptable as part of a fall arrest system because it would not evenly distribute force to the body in the event of a fall and could result in injuries.            Abatement:    Among other methods, one feasible and acceptable abatement method to correct the hazard is to provide a body harness and a short lanyard that would ensure restraint and prevent employees from falling from the basket of the aerial lift.      Abatement Note:  Abatement certification is required for this item (see enclosed Sample Abatement-Certification Letter).
Recent events (2)
  • — I (S) $750
  • — Z (S) $2550

1910.67 C02 IV

Deleted Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.67(c)(2)(iv):  Employees did not always stand firmly on the floor of the basket, and were allowed to sit or climb on the edge of the basket or use planks, ladders, or other devices for a work position:    a)  On or about March 25, 2011, an employee was exposed to fall hazards while removing holiday lights from trees because he did not keep his feet firmly on the floor of the basket of the aerial lift that he was using.  At times, the employee climbed the side of the basket to access the lights.     Abatement Note:  Abatement certification is required for this item (see enclosed Sample Abatement-Certification Letter).
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 330290883.