EDWARDS, CO ·
OSHA Inspection: BUXMAN ENTERPRISES, LTD
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of BUXMAN ENTERPRISES, LTD in 34295 HIGHWAY 6, EDWARDS, CO 81632 (NAICS 445110). OSHA activity number 330970286.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- BUXMAN ENTERPRISES, LTD
- Site address
- 34295 HIGHWAY 6
- City
- EDWARDS
- State
- CO
- ZIP
- 81632
- Mailing
- 34295 HIGHWAY 6, EDWARDS, CO 81632
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 445110
- Employees
- 38
- Ownership type
- Private (A)
Citations
8 citations on file for this inspection.
5(a)(1)
- Issued
- Dec 13, 2011
- Abate by
- Dec 28, 2011
- Penalty
- Initial $2,142 · Current $1,071 Reduced
General-duty citation text
Section (5) (a) (1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which was free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of falling when ascending and descending portable metal ladders to gain access to the roof top of the dairy refrigerator unit, which was used as a overhead storage mezzanine: (a) Buxman Enterprises, LTD., @ 34295 Highway 6, Edwards, CO. On or before July 16, 2011, the employer did not ensure that an appropriate portable ladder that will extend at least 3 feet above the dairy cooler roof top was provided to enable safe egress and access to the overhead storage mezzanine. This condition exposed employees to the hazard of falling from elevation at an approximate height of 92 to the ground. Additional portable ladders safety requirements were not met as follows: 1) The employer did not ensure that because of the ladder length and type, the top of top step of the stepladder was being used by employees to gain access to the roof top of the dairy refrigerator unit. This condition exposed the employees to the hazard of loosing balance and/or tipping the ladder over sideways or causing the stepladder base to slide. Portable ladders are not designed for excessive side loading. It should be avoided. This condition exposed employees to the hazard of falling from elevation at an approximate height of 92 to the ground. 2) The employer did not ensure that each employee who used portable metal ladders was provided adequate ladder safety training as required under the standard. This condition exposed the employees to the hazard of falling when ascending and descending portable metal ladders to gain access to the roof top of the dairy refrigerator unit, which was used as an overhead storage mezzanine. 5 (a) (1) ELEMENTS: 1. The employer failed to keep the workplace free of hazards to which employees of the employer were exposed to the hazard of falling when ascending and descending portable metal ladders to gain access to the roof top of the dairy refrigerator unit, which was used as an overhead storage mezzanine: 2. The hazard is a recognized hazard under the ANSI-A14-2-2000 to reduce exposing employees to the hazard of falling when ascending and descending portable metal ladders to gain access to the roof top of the dairy refrigerator unit, which was used as an overhead storage mezzanine: 3. The hazard is causing or likely to cause serious physical harm the employer did not ensure that an appropriate portable ladder that will extend at least 3 feet above the dairy cooler roof top was provided to enable safe egress and access to the overhead storage mezzanine. This condition exposed employees to the hazard of falling from elevation at an approximate height of 92 to the ground. 4. Among other methods, one feasible and acceptable abatement methods to correct the hazard is to ensure that when portable ladders are used to gain access to upper access levels, they shall be extended at least 3 feet above the roof top line to enable safe access and egress.
Recent events (2)
- · I (S) $1071
- · Z (S) $2142
1910.23 C01
- Issued
- Dec 13, 2011
- Abate by
- Dec 28, 2011
- Penalty
- Initial $2,677 · Current $1,338 Reduced
General-duty citation text
29 CFR 1910.23(c)(1) 29 CFR 1910.23(c)(1): Open sided floor(s) or platform(s) 4 feet or more above the adjacent floor or ground level were not guarded by standard railings (or the equivalent as specified in 29 1910.23(e)(3)(i) through (v)), on all open sides: (a) Buxman Enterprises, LTD., @ 34295 Highway 6, Edwards, CO. On or before July 16, 2011, the employer did not ensure that standard guardrails systems or any other suitable fall protection systems was provided on the open-sided roof of the dairy refrigerator unit used as a overhead storage mezzanine. This condition exposed employees to the hazard of falling from elevation at an approximate height of 92 to the ground. On July 1, 2011, an employee while looking for supplies stored on top of the dairy refrigerator unit, fell through one of the suspended ceiling panels landing on the floor of aisle # 8. Abatement Note: The following is provided to assist in the abatement of this hazard: (1) A standard railing shall consist of top rail, intermediate rail, and posts, and shall have a vertical height of 42 inches nominal from upper surface of top rail to floor, platform, runway, or ramp level. The top rail shall be smooth-surfaced throughout the length of the railing. The intermediate rail shall be approximately halfway between the top rail and the floor, platform, runway, or ramp. The ends of the rails shall not overhang the terminal posts except where such overhang does not constitute a projection hazard. (2) A standard toeboard shall be 4 inches nominal in vertical height from its top edge to the level of the floor, platform, runway, or ramp. It shall be securely fastened in place and with not more than 1/4-inch clearance above floor level. It may be made of any substantial material either solid or with openings not over 1 inch in greatest dimension.
Recent events (2)
- · I (S) $1338
- · Z (S) $2677
1910.212 A01
- Issued
- Dec 13, 2011
- Abate by
- Dec 28, 2011
- Penalty
- Initial $1,606 · Current $803 Reduced
General-duty citation text
29 CFR 1910.212(a)(1): Machine guarding was not adequately provided to protect operator(s) and other employees from hazard(s) created by moving and rotating parts during operating cycles: (a) Buxman Enterprises, LTD., @ 34295 Highway 6, Edwards, CO. On or before July 16, 2011, the employer did not ensure that guard made out of expandable metal attached on the interlocking door for the cardboard compactor was adequately and securely fasten in place to prevent detachment during the operating cycles. This condition exposed employees to the hazards such as those created by moving parts in an event of accidental contact.
Recent events (2)
- · I (S) $803
- · Z (S) $1606
1910.303 G01 I
- Issued
- Dec 13, 2011
- Abate by
- Jan 5, 2012
- Penalty
- Initial $2,142 · Current $1,071 Reduced
General-duty citation text
29 CFR 1910.303(g)(1)(i): Sufficient access and working space was not provided and maintained on all electric equipment to permit ready and safe operation and maintenance of such electrical equipment rated @ 600 volts or less, as specified in Table S-1: Buxman Enterprises, LTD., @ 34295 Highway 6, Edwards, CO. On or before July 16, 2011, the employer did not ensure that the working space in front of the electrical panels on the east wall in facing the dairy cooler was maintained at a minimum clear working space of 3 feet. Boxes and other items were being stored along the wall on the floor reducing the space and presenting a potential electrical hazard to the employees needing access to the panels.
Recent events (2)
- · I (S) $1071
- · Z (S) $2142
1910.305 B02 I
- Issued
- Dec 13, 2011
- Abate by
- Dec 28, 2011
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.305(b)(2)(i) Each pull box, junction box in completed installation did not have a cover faceplate, or fixture canopy: Buxman Enterprises, LTD., @ 34295 Highway 6, Edwards, CO. On or before July 16, 2011, the employer did not ensure that the junction box at the ceiling above the dairy cooler floor containing unprotected and exposed conductors was properly provided with a cover plate to prevent accidental electrical shock to employees working on the overhead storage mezzanine.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1910.305 G01 IV A
- Issued
- Dec 13, 2011
- Abate by
- Dec 28, 2011
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.305(g)(1)(iv)(A): Flexible cords and cables were used as a substitute for the fixed wiring of a structure: (a) Buxman Enterprises, LTD., @ 34295 Highway 6, Edwards, CO. On or before July 16, 2011, the employer did not ensure an extension orange cord plugged into a receptacle at the roof of the cooler adjacent to the employees break bench was used as a substitute for the fixed wiring of a structure for purpose to powering appliances such but not limited to lights, clock and a microwawe oven, and other equipment. This condition exposed the employees to an electrical hazard.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1910.22 D01
- Issued
- Dec 13, 2011
- Abate by
- Dec 28, 2011
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.22(d)(1) 29 CFR 1910.22(d)(1): Areas used for mercantile, business, industrial, or other storage purposes shall be provided with a floor loading plate with the approval of the building officials or other qualified sources and posted in a conspicuous place: Buxman Enterprises, LTD., @ 34295 Highway 6, Edwards, CO. On or before July 16, 2011, the employer did not ensure the roof loading capacity was conspicuously marked on the dairy refrigerator unit, which was being used as an overhead storage mezzanine. This condition exposed employees to the hazard of being struck by falling materials due to possible roof collapsed due to overloading.
Recent events (2)
- · I (O) $0
- · Z (O) $0
1904.29 A
- Issued
- Dec 13, 2011
- Abate by
- Dec 28, 2011
- Penalty
- Initial $536 · Current $268 Reduced
General-duty citation text
29 CFR 1904.29(a): A log of all Work-Related Injuries and Illnesses (OSHA Form 300), and/or the Summary of Work-Related Injuries and Illnesses, (OSHA Form 300-A), and/or the Injury and Illness Incident Report (OSHA Form 301) or equivalent forms were not kept by the establishment: (a) Buxman Enterprises, LTD., @ 34295 Highway 6, Edwards, CO. On or before July 16, 2011, the employer did not maintain a log of all Work-Related Injuries and Illnesses (OSHA Form 300), and/or the Summary of Work-Related Injuries and Illnesses, (OSHA Form 300-A), and/or the Injury and Illness Incident Report (OSHA Form 301) or equivalent forms for the previous three years as required under the Recordkeeping Requirements. Abatement Note: Basic requirement. You must use OSHA 300, 300-A, and 301 forms, or equivalent forms, for recordable injuries and illnesses. The OSHA 300 form is called the Log of Work-Related Injuries and Illnesses, the 300-A is the Summary of Work-Related Injuries and Illnesses, and the OSHA 301 form is called the Injury and Illness Incident Report.
Recent events (2)
- · I (O) $268
- · Z (O) $535.5
More inspections in this industry (NAICS 445110)
More inspections in CO
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 330970286.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.