Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: DIAMOND MANUFACTURING OF BLUFFTON, LTD

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of DIAMOND MANUFACTURING OF BLUFFTON, LTD in 505 EAST JEFFERSON, BLUFFTON, OH 45817 (NAICS 332999). OSHA activity number 331111948.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Diamond Manufacturing of Bluffton, LTD — free Get an email when a new federal OSHA severe-injury report for Diamond Manufacturing of Bluffton, LTD is published. One employer, no account, unsubscribe in one click.
Site address
505 EAST JEFFERSON
City
BLUFFTON
State
OH
ZIP
45817
Mailing
505 EAST JEFFERSON, BLUFFTON, OH 45817
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332999
Employees
45
Ownership type
A

3 citations on file for this inspection.

1910.178 Q07

Other-than-serious 1 instance 1 exposed
Issued
Jul 11, 2012
Abate by
Jul 21, 2012
Penalty
Initial $1,785 · Current $0 Reduced
29 CFR 1910.178(q)(7): Industrial trucks were not examined before being placed in service, or were placed in service if the examination showed conditions adversely affecting the safety of the vehicle:     a) Diamond Manufacturing of Bluffton, located on 505 East Jefferson Street in Bluffton, OH:  On or about January 12, 2012, the employer did not assure that defects that could potentially affect the safety of the forklift were reported and corrected immediately.  The forklift trucks tires were damaged and it had a hydraulic leak that potentially exposed an employee to stability and struck by hazards.
Recent events (3)
  • — F (O) $0
  • — C (S) $1785
  • — Z (S) $1785

1910.179 N04 I

Deleted Serious Gravity 5 1 instance 1 exposed
Issued
Jul 11, 2012
Abate by
Jul 21, 2012
Penalty
Initial $2,380 · Current $0 Reduced
29 CFR 1910.179(n)(4)(i): At the beginning of each operator's shift, the upper limit switch of each hoist shall be tried out under no load. Extreme care shall be exercised; the block shall be "inched" into the limit or run in at slow speed. If the switch does not operate properly, the appointed person shall be immediately notified:    a) Diamond Manufacturing of Bluffton, located on 505 East Jefferson Street in Bluffton, OH: On or about January 12, 2012, the employer did not assure that at the beginning of each shift that equipment such as, but not limited to, the upper limit switch on the 2 ton crane in the saw area was checked under no load
Recent events (3)
  • — F (S) $0
  • — C (S) $2380
  • — Z (S) $2380

1910.252 B02 III

Deleted Serious Gravity 5 2 instances 2 exposed
Issued
Jul 11, 2012
Abate by
Jul 21, 2012
Penalty
Initial $2,380 · Current $0 Reduced
29 CFR 1910.252(b)(2)(iii): Protection from arc welding rays. Where the work permits, the welder should be enclosed in an individual booth painted with a finish of low reflectivity such as zinc oxide (an important factor for absorbing ultraviolet radiations) and lamp black, or shall be enclosed with noncombustible screens similarly painted. Booths and screens shall permit circulation of air at floor level. Workers or other persons adjacent to the welding areas shall be protected from the rays by noncombustible or flameproof screens or shields or shall be required to wear appropriate goggles:    a) Diamond Manufacturing of Bluffton, located on 505 East Jefferson Street in Bluffton, OH: On or about January 12, 2012, the employer did not ensure that the welding area in the facility was enclosed with noncombustible or flameproof screens or shields, exposing employees, adjacent to the welding area, to eye injuries from the welding rays.
Recent events (3)
  • — F (S) $0
  • — C (S) $2380
  • — Z (S) $2380

View Diamond Manufacturing of Bluffton, LTD's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 331111948.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.