WATERTOWN, NY —
OSHA Inspection: DC BUILDING SYSTEMS, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of DC BUILDING SYSTEMS, INC. in DAVIDSON GM, 18230 US ROUTE 11, WATERTOWN, NY 13601 (NAICS 236220). OSHA activity number 334099439.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- DC BUILDING SYSTEMS, INC.
- Site address
- DAVIDSON GM, 18230 US ROUTE 11
- City
- WATERTOWN
- State
- NY
- ZIP
- 13601
- Mailing
- 18621 US ROUTE 11, WATERTOWN, NY 13601
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236220
- Employees
- 10
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.304 F
- Issued
- May 29, 2012
- Abate by
- Jun 8, 2012
- Penalty
- Initial $3,850 · Current $0 Reduced
General-duty citation text
1926.304(f) Section 5.1.3.3 American National Standards Institute 01.1-1975, Safety Code for Woodworking Machinery as adopted by 29 CFR 1926.304(f): Electrically driven equipment was not equipped with magnetic switches or other devices that will prevent automatic restarting of the machine after a power failure: a) West side of building, service bays, on or about 4-26-12: Employees were operating a table saw that was not equipped with a magnetic switch or anti-restart device.
Recent events (3)
- — J (S) $0
- — C (S) $3850
- — Z (S) $3850
1926.405 A02 II I
- Issued
- May 29, 2012
- Abate by
- Sep 5, 2012
- Penalty
- Initial $2,310 · Current $2,500
General-duty citation text
29 CFR 1926.404(b)(1)(ii): On a construction site, where an assured equipment grounding program was not utilized, all 120-volt, single-phase, 15 and 20 ampere receptacle outlets which were not a part of the permanent wiring of the building or structure and which are in use by employees did not have approved ground fault circuit interrupters for personal protection: a) East wall of building, entry area, on or about 4-26-12: Employees were operating a hand held circular saw and various other power tools, powered through a duplex receptacle and extension cord that was not protected by a ground fault circuit interrupter (GFCI). 29 CFR 1926.405(a)(2)(ii)(I): Protection was not provided to avoid damage to flexible cords and cables used for temporary wiring which passed through doorways or other pinch points: a) East wall of building, entry area, on or about 4-26-12: Employees were operating a hand held circular saw and various other power tools, powered through an extension cord that was pinched beneath a closed aluminum door and aluminum threshold.
Recent events (3)
- — J (S) $2500
- — C (S) $3080
- — Z (S) $3080
1926.405 G02 III
- Issued
- May 29, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.405(g)(2)(iii): Flexible cords were not used in continuous lengths without splice or tap: a) East wall of building, entry area, on or about 4-26-12: Employees were operating a hand held circular saw and various other power tools, powered through an extension cord that was not continuous in length, with multiple splices.
Recent events (3)
- — J (S) $0
- — C (S) $0
- — Z (S) $0
1926.405 J01 V
- Issued
- May 29, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.405(j)(1)(v): Fixtures installed in wet or damp locations were not identified for the purpose, and were not installed so that water cannot enter or accumulate in wireways, lampholders, or other electrical parts: a) East wall of building, entry area, on or about 4-26-12: Employees were operating a hand held circular saw and various other power tools, powered through an extension cord with a 3-way portable receptacle that was laying in standing water.
Recent events (3)
- — J (S) $0
- — C (S) $0
- — Z (S) $0
More inspections at DC Building Systems, INC.
View DC Building Systems, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 236220)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 334099439.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.