CHICAGO, IL —
OSHA Inspection: CUSTOM REMODELING, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of CUSTOM REMODELING, INC. in 2400 W. OGDEN AVE, CHICAGO, IL 60612 (NAICS 238160). OSHA activity number 334327533.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- CUSTOM REMODELING, INC.
- Site address
- 2400 W. OGDEN AVE
- City
- CHICAGO
- State
- IL
- ZIP
- 60612
- Mailing
- 14008 KEELER AVENUE, ALSIP, IL 60803
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 4
- Ownership type
- A
Citations
2 citations on file for this inspection.
1926.501 B03
- Issued
- Aug 7, 2012
- Abate by
- Aug 14, 2012
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.501(b)(3): "Hoist areas." Each employee in a hoist area shall be protected from falling 6 feet (1.8 m) or more to lower levels by guardrail systems or personal fall arrest systems. If guardrail systems, [or chain, gate, or guardrail] or portions thereof, are removed to facilitate the hoisting operation (e.g., during landing of materials), and an employee must lean through the access opening or out over the edge of the access opening (to receive or guide equipment and materials, for example), that employee shall be protected from fall hazards by a personal fall arrest system. a. On or about May 16, 2012 - at the above addressed jobsite, an employee engaged in removing materials from a roof approximately fifty (50) feet above the ground was exposed to fall hazards when no fall protection was used in the material handling area.
Recent events (3)
- — A (S) $2800
- — I (S) $1400
- — Z (S) $2800
1926.501 B10
- Issued
- Aug 7, 2012
- Abate by
- Aug 14, 2012
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.501(b)(10): "Roofing work on Low-slope roofs." Except as otherwise provided in paragraph (b) of this section, each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Or, on roofs 50-feet (15.25 m) or less in width (see Appendix A to subpart M of this part), the use of a safety monitoring system alone [i.e. without the warning line system] is permitted. a. On or about May 16, 2012 - at the above addressed jobsite, employees engaged in roofing work from a low sloped roof, approximately fifty (50) feet above the ground, were not protected from falls, thereby exposing the employees to fall hazards.
Recent events (3)
- — A (S) $2800
- — I (S) $1400
- — Z (S) $2800
More inspections in this industry (NAICS 238160)
More inspections in IL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 334327533.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.