Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,194,531Inspections Most recent open 2026-08-11 Last loaded 2026-08-14

OSHA Inspection: TIM CORDER CONSTRUCTION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of TIM CORDER CONSTRUCTION in 44 LOCUST ST., NEWARK, OH 43055 (NAICS 238130). OSHA activity number 334351723.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch TIM Corder Construction for free Get an email when a new federal OSHA severe-injury report for TIM Corder Construction is published. One employer, no account, unsubscribe in one click.
Site address
44 LOCUST ST.
City
NEWARK
State
OH
ZIP
43055
Mailing
516 DORAL DR., NEWARK, OH 43055
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

5 citations on file for this inspection.

1910.178 L01 II

Serious Gravity 5 1 instance 5 exposed
Issued
Jun 20, 2012
Abate by
Jul 20, 2012
Penalty
Initial $1,600 · Current $640 Reduced
29 CFR 1910.178(l)(1)(ii):     Prior to permitting an employee to operate a powered industrial truck (except for training purposes), the employer shall ensure that each operator has successfully completed the training required by this paragraph (l), except as permitted by paragraph (l)(5).    a.    On the construction site in Heath, Ohio where framing was performed, the employer did not have a trained powered industrial truck operator operating the forklift thereby exsposing employees to a struck-by hazard.
Recent events (2)
  • · I (S) $640
  • · Z (S) $1600

1926.501 B13

Serious Gravity 5 1 instance 3 exposed
Issued
Jun 20, 2012
Abate by
Jun 27, 2012
Penalty
Initial $2,000 · Current $800 Reduced
29 CFR 1926.501(b)(13):     "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure.    a.     On the south side o the building beinf framed, employees were observed walking the top plate and did not use alternative means of fall protection thereby exposing employees to a fall hazard.
Recent events (2)
  • · I (S) $800
  • · Z (S) $2000

1926.503 A01

Deleted Serious Gravity 1 1 instance 5 exposed
Issued
Jun 20, 2012
Abate by
Jul 20, 2012
Penalty
Initial $1,200 · Current $0 Reduced
29 CFR 1926.503(a)(1):     The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. The employees must know the correct procedures for erecting, maintaining, disassembling, and inspecting the fall protection systems to be used;    a.    On the site where employees prformed framing at heights which exceeded six feet the employer did not provide a raining program to address the proper procedures for determining a fall protection system or alternative measures which would protect employees thereby exposing the employees to a fall hazard.
Recent events (2)
  • · I (S) $0
  • · Z (S) $1200

1926.1053 B01

Other-than-serious 1 instance 3 exposed
Issued
Jun 20, 2012
Abate by
Jun 27, 2012
Penalty
Initial $2,000 · Current $0 Reduced
29 CFR 1926.1053(b)(1):     When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.    a.     On the south side of the building the employer used a 8 foot step ladder for employees to gain access to a 12 foot top plate wall to perform framing therebybexposing the employees to a fall hazard.
Recent events (2)
  • · I (O) $0
  • · Z (S) $2000

1926.1053 B13

Other-than-serious 1 instance 4 exposed
Issued
Jun 20, 2012
Abate by
Jun 27, 2012
Penalty
Initial $2,000 · Current $0 Reduced
29 CFR 1926.1053(b)(13):     The top or top step of a stepladder shall not be used as a step.    a.     On the south side of the building where employees used an 8 foot step ladder to gain access and exit the top of the framed buiding, the employees used the top step of the ladder as it was leaning up against the wall thereby exposing employees to a fall hazard.
Recent events (2)
  • · I (O) $0
  • · Z (S) $2000

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 334351723.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.