WASHINGTON, DC —
OSHA Inspection: PHOENIX CONCRETE CUTTING, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of PHOENIX CONCRETE CUTTING, INC. in 805 CHANNING PLACE NE, WASHINGTON, DC 20018 (NAICS 238140). OSHA activity number 334372125.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- PHOENIX CONCRETE CUTTING, INC.
- Site address
- 805 CHANNING PLACE NE
- City
- WASHINGTON
- State
- DC
- ZIP
- 20018
- Mailing
- 9103 51ST PLACE, COLLEGE PARK, MD 20740
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238140
- Employees
- 3
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.34 C
- Issued
- Jun 28, 2012
- Penalty
- Initial $1,020 · Current $510 Reduced
General-duty citation text
29 CFR 1926.34(c): Means of egress shall be continually maintained free of all obstructions or impediments to full instant use in the case of fire or other emergency. a) Exit Door, 1st Floor, North Face of Building - A stack of metal pipes and plastic tubing was observed blocking a designated exit door obstructing egress in the event of an emergency.
Recent events (2)
- — I (S) $510
- — Z (S) $1020
1926.453 B02 V
- Issued
- Jun 28, 2012
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1926.453(b)(2)(v): A body belt shall be worn and a lanyard attached to the boom or basket when working from an aerial lift. Note to paragraph (b)(2)(v): As of January 1, 1998, subpart M of this part (1926.502(d)) provides that body belts are not acceptable as part of a personal fall arrest system. The use of a body belt in a tethering system or in a restraint system is acceptable and is regulated under 1926.502(e). a) Genie S-65 Aerial Lift - An employee was observed working in an elevated position from a Genie S-65 aerial lift without wearing a body belt (or harness) that was attached by a lanyard to the boom or basket. The employee was exposed to a fall from elevation of greater than 40 feet to the hard earth below.
Recent events (2)
- — I (S) $1400
- — Z (S) $2800
1926.501 B01
- Issued
- Jun 28, 2012
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1926.501(b)(1): Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems. a) Roof - Employees were observed working from a commercial flat roof without fall protection and were exposed to a fall from elevation of greater than 40 feet
Recent events (2)
- — I (S) $1400
- — Z (S) $2800
1926.503 A01
- Issued
- Jun 28, 2012
- Abate by
- Jul 31, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. a) Roof - The employer did not provide training for an employee who was working on a commerical roof. The employee was exposed to a fall from elevation of greater than 40 feet. ABATEMENT DOCUMENTATION REQUIRED
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections at Phoenix Concrete Cutting, INC.
View Phoenix Concrete Cutting, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238140)
More inspections in DC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 334372125.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.