OSHA Inspection: DAVID SCRIPTURE

Issued

2012-07-13 00:00:00

Abate by

2012-07-16 00:00:00

Penalty

Initial $2800.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.300(b)(1): Power operated tool(s), designed to accommodate guards, were not equipped with such guards when in use:    a. Site- Employees were exposed to amputation hazards when a Ryobi table saw was being operated with the guard removed.

Issued

2012-07-13 00:00:00

Abate by

2012-07-16 00:00:00

Penalty

Initial $2800.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.501(b)(13): Employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph (b)    a. Site- Employees were not protected from falls of approximately 9 feet 5 inches when fall protection was not used or provided.

Issued

2012-07-13 00:00:00

Abate by

2012-08-03 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.503(a)(2): The employer did not assure that each employee exposed to fall hazards was trained by a competent person qualified in the areas specified in 29 CFR 1926.503 (a)(2)(i) through (viii).    a.Site- Employees were not protected from falls of approximately 9 feet 5 inches when fall protection training was not provided by the employer.

Issued

2012-07-13 00:00:00

Abate by

2012-07-16 00:00:00

Penalty

Initial $2000.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladders length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:    a. Site- Employees were not protected from falls of approximately 9 feet 5 inches when a ladder used for access to the roof did not extend 3 feet above the upper landing surface.

Issued

2012-07-13 00:00:00

Abate by

2012-07-16 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.403(b)(2): Listed, labeled, or certified equipment was not installed and used in accordance with instructions included in the listing, labeling, or certification:    a. Site- employees using a 6 outlet wall tap, which was plugged into a GFCI protected electrical outlet, was not done in accordance with its equipments listing and labeling requirements where it was meant for indoor use only.

Issued

2012-07-13 00:00:00

Abate by

2012-07-16 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.405(g)(2)(iv): Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws:    a. Site- employees were allowed to use a damaged cord, which was plugged into a GFCI protected outlet that lacked adequate strain relief.