Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,191,871Inspections Most recent open 2026-07-30 Last loaded 2026-08-03

OSHA Inspection: FRED WENGER

Unprogrammed Other inspection · Safety discipline

On , OSHA opened an unprogrammed Other safety inspection of FRED WENGER in 1108 CLINTON ST, BLOOMINGTON, IL 61701 (NAICS 238160). OSHA activity number 334436359.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Fred Wenger for free Get an email when a new federal OSHA severe-injury report for Fred Wenger is published. One employer, no account, unsubscribe in one click.
Establishment
FRED WENGER
Site address
1108 CLINTON ST
City
BLOOMINGTON
State
IL
ZIP
61701
Mailing
1101 EKSTAM DR #202, BLOOMINGTON, IL 61705
Inspection type
Unprogrammed Other (I)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
3
Ownership type
A

5 citations on file for this inspection.

1926.403 B02

Serious Gravity 1 1 instance 3 exposed
Issued
Jun 1, 2012
Abate by
Jun 22, 2012
Penalty
Initial $1,200 · Current $1,200
29 CFR 1926.403(b)(2):     Listed, labeled, or certified equipment was not installed and used in accordance with instructions included in the listing, labeling, or certification:    Employees using a metal receptacle box were exposed to electrical hazards.  The employees were plugging extension cords into an unmounted four receptacle handy box and the metal box was not used according to its listing requirements.
Recent events (1)
  • · Z (S) $1200

1926.501 B13

Serious Gravity 10 1 instance 3 exposed
Issued
Jun 1, 2012
Abate by
Jun 22, 2012
Penalty
Initial $2,800 · Current $2,800
29 CFR 1926.501(b)(13):      Employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were other provisions of paragraph (b) of this section used to provided an alternative fall protection measure:    Employees replacing a residential roof were exposed to fall hazards of approximately 24 feet.  No fall protection was utilized.
Recent events (1)
  • · Z (S) $2800

1926.503 A01

Serious Gravity 5 1 instance 3 exposed
Issued
Jun 1, 2012
Abate by
Jun 22, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1):      The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:    Employees replacing a residential roof were exposed to fall hazards of approximately 19 feet.  A training program was not provided to enable each employee to recognize the hazards of falling.
Recent events (1)
  • · Z (S) $0

1926.1053 B01

Serious Gravity 10 1 instance 3 exposed
Issued
Jun 1, 2012
Abate by
Jun 22, 2012
Penalty
Initial $2,800 · Current $2,800
29 CFR 1926.1053(b)(1):      Portable ladders were used for access to an upper landing surface and the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface to which the ladder was used to gain access:    Employees using a portable extension ladder to access a roof were exposed to fall hazards.  The step ladder side rails extended approximately one foot above the upper landing surface.
Recent events (1)
  • · Z (S) $2800

1926.1060 A

Serious Gravity 5 1 instance 3 exposed
Issued
Jun 1, 2012
Abate by
Jun 22, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.1060(a):      The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards:    Employees using an aluminum extension ladder to access a roof were exposed to fall hazards of approximately 24 feet.  The employees had not been trained so far as to enable each employee to recognize hazards related to ladders and procedures to follow in order to minimize those hazards.
Recent events (1)
  • · Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 334436359.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.