OSHA Inspection: PERGAN MARSHALL, LLC

Issued

Dec 13, 2012

Abate by

Dec 26, 2012

Penalty

Initial $2,100 · Current $1,260 Reduced

General-duty citation text

29 CFR 1910.22(a)(1):      All places of employment, passageways, storerooms, and service rooms were not kept clean and orderly and in a sanitary condition:    This violation was discovered on July 27, 2012; in the maintenance parts warehouse where parts, pallets and equipment were cluttering up passageways.

Issued

Dec 13, 2012

Abate by

Dec 26, 2012

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.22(a)(2):     Floor(s) of workroom(s) were not maintained in a so far as possible, a dry condition:    This violation was discovered on July 27, 2012; in the compressor room where water and oil on the floor resulted in a wet, slippery surface.

Issued

Dec 13, 2012

Abate by

Apr 1, 2013

Penalty

Initial $4,900 · Current $2,940 Reduced

General-duty citation text

29 CFR 1910.119(e)(3)(i):     The process hazard analysis did not address all hazards involved in the process:    This violation was discovered on, July 6, 2012; where all utility systems that could affect or cause a release of highly hazardous chemicals or interfere in the mitigation of the consequences of a release were not addressed in the process hazard analysis.

Issued

Dec 13, 2012

Abate by

Apr 1, 2013

Penalty

Initial $3,500 · Current $2,100 Reduced

General-duty citation text

29 CFR 1910.119(j)(4)(iii):     The frequency of inspections and tests of process equipment was not consistent with applicable manufacturers' recommendations and good engineering practices, or more frequently if determined to be necessary by prior operating experience:    This violation was discovered on August 16, 2012 as described below:     a.)  The Ultrasonic Thickness inspection for R-100 due on January 22, 2011 was not completed.  b.)  The External Visual inspection for R-100 due on November 28, 2008 was not completed.  c.)  The Ultrasonic Thickness inspection for R-200 due on October 04, 2011 was not completed.  d.)  The External Visual inspection for R-100 due on July 4, 2009 was not completed.  e.)  The Ultrasonic Thickness inspection for R-400A due on October 04, 2011 was not completed.  f.)   The External Visual inspection for R-400A due on October 04, 2011 was not completed.  g.)  The Internal inspection for R-400A due on August 16, 2012 was not completed.  h.)  The Ultrasonic Thickness inspection for R-400B due on October 04, 2011 was not completed.  i.)   The External Visual inspection for R-400B due on October 04, 2011 was not completed.  j.)   The Internal inspection for R-400B due on August 16, 2012 was not completed.  k.)  The Ultrasonic Thickness inspection for R-400C due on October 05, 2011 was not completed.  l.)   The External Visual inspection for R-400C due on October 05, 2011 was not completed.  m.) The annual internal inspection for T-900 was last completed on October 9, 2007.  n.)  The annual internal inspection for T-910 was last completed on October 9, 2007.  o.)  The annual internal inspection for T-920 was last completed on October 9, 2007.

Issued

Dec 13, 2012

Abate by

Dec 26, 2012

Penalty

Initial $3,500 · Current $0 Reduced

General-duty citation text

29 CFR 1910.147(c)(4)(i):     The employer's energy control procedures did not include speciific steps or procedures to be followed for purging lines, tanks, or vessels:      This violation was discovered on July 6, 2012; where employees performing maintenance activities did not have equipment specific procedures developed and documented to be utilized for the control of hazardous energy.