Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: CREATIVE SPACE DESIGN, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of CREATIVE SPACE DESIGN, INC. in 31 PROSPECT AVE, MOUNT VERNON, NY 10550 (NAICS 238310). OSHA activity number 334908993.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Creative Space Design, INC. — free Get an email when a new federal OSHA severe-injury report for Creative Space Design, INC. is published. One employer, no account, unsubscribe in one click.
Site address
31 PROSPECT AVE
City
MOUNT VERNON
State
NY
ZIP
10550
Mailing
792 MCLEAN AVE., YONKERS, NY 10704
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238310
Employees
6
Ownership type
A

5 citations on file for this inspection.

1926.21 B02

Serious Gravity 1 6 instances 6 exposed
Issued
Jul 12, 2012
Penalty
Initial $1,200 · Current $720 Reduced
29 CFR 1926.21(b)(2): The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury.      On or about 6/28/2012, Job Site    a) The employees were not provided safety and health training as required by the standard.
Recent events (2)
  • — I (S) $720
  • — Z (S) $1200

1926.404 B01 I

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 12, 2012
Penalty
Initial $1,600 · Current $960 Reduced
29 CFR 1926.404(b)(1)(i): General. The employer shall use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites. These requirements are in addition to any other requirements for equipment grounding conductors.    On or about 6/28/2012, Job Site    a) The employee was cutting wood with the Milwaukee skilsaw. The employee was not using a ground fault circuit interrupter.
Recent events (2)
  • — I (S) $960
  • — Z (S) $1600

1926.404 F06

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 12, 2012
Penalty
Initial $1,600 · Current $960 Reduced
29 CFR 1926.404(f)(6): Grounding path. The path to ground from circuits, equipment, and enclosures shall be permanent and continuous.    On or about 6/28/2012, Food Town    a) The employee was using a 25' extension cord to energize his skilsaw. The ground pin was broken off.
Recent events (2)
  • — I (S) $960
  • — Z (S) $1600

1926.501 B01

Serious Gravity 10 1 instance 2 exposed
Issued
Jul 12, 2012
Penalty
Initial $2,800 · Current $1,680 Reduced
29 CFR 1926.501(b)(1): "Unprotected sides and edges." Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems.    On or about 6/28/2012, Food Town    a) The employees were working on the roof, which measured 70' long, 8'wide and approximately 14' hiigh. They were not  protected from falling approximately 14' to the ground below.
Recent events (2)
  • — I (S) $1680
  • — Z (S) $2800

1926.1053 B04

Serious Gravity 1 1 instance 2 exposed
Issued
Jul 12, 2012
Penalty
Initial $1,200 · Current $720 Reduced
29 CFR 1926.1053(b)(4): Ladders shall be used only for the purpose for which they were designed.    On or about 6/28/2012, Mezzanine Roof    a) The A-frame ladder was used to gain access to the roof. It was used in the closed position.
Recent events (2)
  • — I (S) $720
  • — Z (S) $1200

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 334908993.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.