Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,195,903Inspections Most recent open 2026-08-18 Last loaded 2026-08-21

OSHA Inspection: ST. CLAIR SHEET METAL

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of ST. CLAIR SHEET METAL in 4606 COUNTRY LANE, SAINT ANN, MO 63074 (NAICS 238160). OSHA activity number 334947983.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch ST. Clair Sheet Metal for free Get an email when a new federal OSHA severe-injury report for ST. Clair Sheet Metal is published. One employer, no account, unsubscribe in one click.
Site address
4606 COUNTRY LANE
City
SAINT ANN
State
MO
ZIP
63074
Mailing
6544 BRICKYARD RD., MASCOUTAH, IL 62258
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
2
Ownership type
Private (A)

3 citations on file for this inspection.

1926.100 A

Serious Gravity 1 1 instance 1 exposed
Issued
Jul 6, 2012
Penalty
Initial $1,200 · Current $1,200
29 CFR 1926.100(a):     Employees working in areas where there is a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns, shall be protected by protective helmets.    An employee working on the ground level where over-head hazard exisited was not required to wear protective helmet.
Recent events (1)
  • · Z (S) $1200

1926.501 B10

Serious Gravity 5 1 instance 2 exposed
Issued
Jul 6, 2012
Abate by
Jul 20, 2012
Penalty
Initial $2,000 · Current $2,000
29 CFR 1926.501(b)(10):     "Roofing work on Low-slope roofs." Except as otherwise provided in paragraph (b) of this section, each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Or, on roofs 50-feet (15.25 m) or less in width (see Appendix A to subpart M of this part), the use of a safety monitoring system alone [i.e. without the warning line system] is permitted.    Employees working on a flat roof were not provided fall protection.
Recent events (1)
  • · Z (S) $2000

1926.1053 B01

Serious Gravity 1 1 instance 2 exposed
Issued
Jul 6, 2012
Penalty
Initial $1,200 · Current $1,200
29 CFR 1926.1053(b)(1):     When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.    At the site, where the employees accessed the roof top of an apartment building, the ladder was not extended three feet above the roof landing.
Recent events (1)
  • · Z (S) $1200

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 334947983.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.