Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: QUALITY CRAFT BUILDERS LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of QUALITY CRAFT BUILDERS LLC in 76 MELBA AVENUE, MILFORD, CT 06460 (NAICS 238130). OSHA activity number 335107181.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Quality Craft Builders LLC — free Get an email when a new federal OSHA severe-injury report for Quality Craft Builders LLC is published. One employer, no account, unsubscribe in one click.
Site address
76 MELBA AVENUE
City
MILFORD
State
CT
ZIP
06460
Mailing
77 CANOE BROOK ROAD, TRUMBULL, CT 06611
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

7 citations on file for this inspection.

1926.451 B05 II

Serious Gravity 10 2 instances 3 exposed
Issued
Sep 28, 2012
Abate by
Oct 3, 2012
Penalty
Initial $2,800 · Current $1,400 Reduced
29 CFR 1926.451(b)(5)(ii): Each platform greater than 10 feet in length shall not extend over its support more than 18 inches (46 cm), unless it is designed and installed so that the cantilevered portion of the platform is able to support employees without tipping, or has guardrails which block employee access to the cantilevered end.    WORKSITE: The both ends of following combination window jack/carpenter bracket scaffold planks extended more than 18 inches beyond the supports and were not secured to prevent accidental displacement, exposing employees to falls between 21-0 and 23-6 to the ground.     1.	The scaffold on the left front of the house.  2.	The scaffold on the right front of the house.
Recent events (2)
  • — I (S) $1400
  • — Z (S) $2800

1926.451 E01

Serious Gravity 10 2 instances 3 exposed
Issued
Sep 28, 2012
Abate by
Oct 3, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.451(e)(1): When scaffold platforms are more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from another scaffold, structure, personnel hoist, or similar surface shall be used. Crossbraces shall not be used as a means of access.    WORKSITE: The two (2) combination window jack/carpenter bracket scaffolds, used by employees to conduct roofing activities were not provided with ladder access onto the scaffolds.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.452 L03

Serious Gravity 10 2 instances 3 exposed
Issued
Sep 28, 2012
Abate by
Oct 3, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.452(l)(3): Window jacks shall not be used to support planks placed between one window jack and another, or for other elements of scaffolding.    WORKSITE: The employer used a window jack scaffold and a carpenter bracket scaffold to support scaffold planking from which employees were conduct roofing activities:    1. On the left side of the house.  2. On the right side of the house.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.451 G01 VII

Serious Gravity 10 2 instances 3 exposed
Issued
Sep 28, 2012
Abate by
Oct 3, 2012
Penalty
Initial $2,800 · Current $1,400 Reduced
29 CFR 1926.451(g)(1)(vii): For all scaffolds not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, each employee shall be protected by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.    WORKSITE: The employees engaged in roofing activities from two (2) window jack/carpenter bracket scaffolds were not protected against the hazards of falling between 21-0 and 23-6 to the ground by the use of personal fall arrest systems or equivalent protection.
Recent events (2)
  • — I (S) $1400
  • — Z (S) $2800

1926.501 B13

Serious Gravity 10 1 instance 3 exposed
Issued
Sep 28, 2012
Abate by
Oct 3, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502.  Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems.    WORKSITE: The employees engaged in roofing activities from a 7 in 12 pitch roof, were not protected against falling by the use of an appropriate fall protection system or equivalent protection.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.454 A

Serious Gravity 5 1 instance 3 exposed
Issued
Sep 28, 2012
Abate by
Oct 5, 2012
Penalty
Initial $2,000 · Current $1,000 Reduced
29 CFR 1926.454(a): The employer shall have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards. The training shall include the following areas, as applicable:    WORKSITE: The employees engaged in roofing activities from two (2) window jack/carpenter bracket scaffolds were not provided with training in the recognition of hazards associated the type of scaffold being used, or the procedures necessary to eliminate or minimize those hazards.
Recent events (2)
  • — I (S) $1000
  • — Z (S) $2000

1926.503 A01

Serious Gravity 5 1 instance 3 exposed
Issued
Sep 28, 2012
Abate by
Oct 5, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.    WORKSITE: The employees engaged in roofing activities from a 7 in 12 pitch roof, were not provided with training in the recognition of hazards associated with falls, or the procedures necessary to eliminate or minimize those hazards.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 335107181.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.