PHILADELPHIA, PA ·
OSHA Inspection: LATINO CONSTRUCTION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of LATINO CONSTRUCTION in 1022-1024 FAIRMOUNT AVE, PHILADELPHIA, PA 19123 (NAICS 238140). OSHA activity number 335136180.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- LATINO CONSTRUCTION
- Site address
- 1022-1024 FAIRMOUNT AVE
- City
- PHILADELPHIA
- State
- PA
- ZIP
- 19123
- Mailing
- 729 W. RITNER ST, PHILADELPHIA, PA 19184
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238140
- Employees
- 4
- Ownership type
- Private (A)
Citations
4 citations on file for this inspection.
1926.451 G04 I
- Issued
- Aug 24, 2012
- Penalty
- Initial $2,800 · Current $1,500 Reduced
General-duty citation text
29 CFR 1926.451(g)(4)(i): Guardrail systems were not installed along all open sides and ends of platforms before being released for use by employees other than erection/dismantling crews: a) Jobsite-1022-1024 Fairmount Ave, Philadelphia, PA- Employees were performing stucco work at approximately 18 ft. above ground level from a tubular welded scaffold which did not have the guardrails along all open sides. Observed on or about 6/15/12. NOTE: No abatement certification or documentation required.
Recent events (2)
- · I (S) $1500
- · Z (S) $2800
1926.451 B01 I
- Issued
- Aug 24, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.451(b)(1)(i): Each platform unit (e.g., scaffold plank, fabricated plank, fabricated deck, or fabricated platform) was not installed so that the space between adjacent units and the space between the platform and the uprights were no more than 1 inch (2.5 cm) wide, except where the employer can demonstrate that a wider space is necessary. a) Jobsite-1022-1024 Fairmount Ave, Philadelphia, PA- Employees were performing stucco work at approximately 18 ft. above ground level from a tubular welded scaffold which was not fully planked. Observed on or about 6/15/12. NOTE: No abatement certification or documentation required.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1926.451 E01
- Issued
- Aug 24, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, sturcure, personnel hoist, or similar surface was not used. Crossbraces were used as a means of access. a) Jobsite-1022-1024 Fairmount Ave, Philadelphia, PA- Employees were performing stucco work at approximately 18 ft. above ground level from a tubular welded scaffold that did not have a means of access such as a ladder. Observed on or about 6/15/12. Note: No abatement certification or documentation required.
Recent events (2)
- · I (S) $0
- · Z (S) $0
1926.454 A
- Issued
- Aug 24, 2012
- Abate by
- Mar 10, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.454(a): The employer shall have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards. The training shall include the following areas, as applicable: a) Jobsite-1022-1024 Fairmount Ave, Philadelphia, PA- Employees were performing stucco work at approximately 18 ft. above ground level from a tubular welded scaffold without scaffold safety training. Observed on or about 6/15/12. Note:Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement
Recent events (2)
- · I (O) $0
- · Z (O) $0
More inspections in this industry (NAICS 238140)
More inspections in PA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 335136180.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.