HICKSVILLE, NY —
OSHA Inspection: AM BHUTTA CONSTRUCTION
Unprogrammed Other inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Other safety inspection of AM BHUTTA CONSTRUCTION in 400 W. OLD COUNTRY RD., HICKSVILLE, NY 11801 (NAICS 236115). OSHA activity number 335339792.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- AM BHUTTA CONSTRUCTION
- Site address
- 400 W. OLD COUNTRY RD.
- City
- HICKSVILLE
- State
- NY
- ZIP
- 11801
- Mailing
- 2124 64TH ST., BROOKLYN, NY 11204
What kind of inspection was it?
- Inspection type
- Unprogrammed Other (I)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236115
- Employees
- 8
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.451 B01
- Issued
- Sep 27, 2012
- Abate by
- Sep 28, 2012
- Penalty
- Initial $2,000 · Current $200 Reduced
General-duty citation text
29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as specified in paragraphs 1926.451(b)(1)(i)-(ii) a) Worksite, Exterior - Employees were working on the first and second tier of a fabricated frame scaffold. The scaffold had two planks installed at each level and was missing four planks; on or about 08/13/12. Note: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.
Recent events (3)
- — C (S) $2000
- — F (S) $200
- — Z (S) $2000
1926.451 E01
- Issued
- Sep 27, 2012
- Abate by
- Sep 28, 2012
- Penalty
- Initial $2,000 · Current $200 Reduced
General-duty citation text
29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, structure, personnel hoist, or similar surface was not used. Crossbraces were used as a means of access. a) Worksite, Exterior - Employees were applying stucco to a commercial building while working off of a fabricated frame scaffold. The employees were not provided with an access ladder and were climbing the scaffold frame to gain access; on or about 8/13/12. Note: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.
Recent events (3)
- — C (S) $2000
- — F (S) $200
- — Z (S) $2000
1926.451 G01
- Issued
- Sep 27, 2012
- Abate by
- Sep 28, 2012
- Penalty
- Initial $2,000 · Current $200 Reduced
General-duty citation text
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section: a) Worksite, Exterior - Employees were applying stucco to a single story commercial building while working on the second tier of a fabricated frame scaffold. The employees were not protected from falling approximately 12ft to the ground below; on or about 8/13/12. Note: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.
Recent events (3)
- — C (S) $2000
- — F (S) $200
- — Z (S) $2000
1926.501 B01
- Issued
- Sep 27, 2012
- Abate by
- Sep 28, 2012
- Penalty
- Initial $2,000 · Current $200 Reduced
General-duty citation text
29 CFR 1926.501(b)(1): Each employee on a walking/working surface with an unprotected side or edge which was 6 feet (1.8 m) or more above a lower level was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems. a) Worksite, Exterior - Employees were applying stucco on a single story commercial building while leaning over the edge of the roof, approximately 20ft above the ground. Employees were not provided with a means of fall protection; on or about 7/21/12. Note: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.
Recent events (3)
- — C (S) $2000
- — F (S) $200
- — Z (S) $2000
1926.503 A01
- Issued
- Sep 27, 2012
- Abate by
- Oct 2, 2012
- Penalty
- Initial $1,600 · Current $200 Reduced
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: a) Worksite, Exterior - Employees were applying stucco on a single story commercial building while leaning over the edge of a flat roof, approximately 20ft above the ground below. The employees were not trained to recognize the hazards associated with falling; on or about 07/21/12. Note: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.
Recent events (3)
- — C (S) $1600
- — F (S) $200
- — Z (S) $1600
More inspections in this industry (NAICS 236115)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 335339792.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.