Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: PROOF ROOFING COMPANY

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of PROOF ROOFING COMPANY in 5218 S LOCKWOOD AVE, CHICAGO, IL 60638 (NAICS 238160). OSHA activity number 335562609.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Proof Roofing Company — free Get an email when a new federal OSHA severe-injury report for Proof Roofing Company is published. One employer, no account, unsubscribe in one click.
Site address
5218 S LOCKWOOD AVE
City
CHICAGO
State
IL
ZIP
60638
Mailing
1019 CAROL STREET, DOWNERS GROVE, IL 60516
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
7
Ownership type
A

5 citations on file for this inspection.

1926.307 D01

Serious Gravity 5 1 instance 1 exposed
Issued
Aug 14, 2012
Abate by
Aug 15, 2012
Penalty
Initial $1,600 · Current $1,600
29 CFR 1926.307(d)(1): "Guarding." Pulleys, any parts of which are 7 feet (2.128 m) or less from the floor or working platform, shall be guarded in accordance with the standards specified in paragraphs (m) and (o) of this section. Pulleys serving as balance wheels (e.g., punch presses) on which the point of contact between belt and pulley is more than 6 ft. 6 in. (1.976 m) from the floor or platform may be guarded with a disk covering the spokes.    a.  On or about August 2, 2012 - at the above addressed jobsite, the pulley and belt on the material hoist ladder engine was not fully enclosed or guarded against accidental contact, thereby exposing the employee to the hazards associated with lacerations.
Recent events (2)
  • — I (S) $1600
  • — Z (S) $1600

1926.307 E01 I

Serious Gravity 5 1 instance 1 exposed
Issued
Aug 14, 2012
Abate by
Aug 15, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.307(e)(1)(i): Where both runs of horizontal belts are 7 feet (2.128 m) or less from the floor level, the guard shall extend to at least 15 inches (38.1 cm) above the belt or to a standard height, except that where both runs of a horizontal belt are 42 inches (106.68 cm) or less from the floor, the belt shall be fully enclosed.    a.  On or about August 2, 2012 - at the above addressed jobsite, the belt on the material hoist ladder engine was not fully enclosed or guarded against accidental contact, thereby exposing the employees to the hazards associated with lacerations.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.501 B13

Serious Gravity 10 1 instance 3 exposed
Issued
Aug 14, 2012
Penalty
Initial $2,800 · Current $400 Reduced
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure.     a.  On or about August 2, 2012 - at the above addressed jobsite, employees performing roofing operations approximately twenty two (22) feet above the ground were not protected from falls, thereby exposing the employees to fall hazards.
Recent events (2)
  • — I (S) $400
  • — Z (S) $2800

1926.503 A01

Serious Gravity 1 1 instance 3 exposed
Issued
Aug 14, 2012
Abate by
Sep 5, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.    a. On or about August 2, 2012 at the above addressed jobsite, the employer failed to provide a training program for each employee exposed to fall hazards.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1053 B01

Other-than-serious 2 instances 3 exposed
Issued
Aug 14, 2012
Penalty
Initial $2,800 · Current $0 Reduced
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.    a.  On or about August 2, 2012 - at the above addressed jobsite, the portable ladder used to access the roof on the North side of the building did not extend at least three (3) feet above the upper landing surface, thereby exposing employees to the hazards associated with falls.    b.  On or about August 2, 2012 - at the above addressed jobsite, the portable ladder used to access the roof on the South side of the building did not extend at least three (3) feet above the upper landing surface, thereby exposing employees to the hazards associated with falls.
Recent events (2)
  • — I (O) $0
  • — Z (S) $2800

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 335562609.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.