PLAINFIELD, IL —
OSHA Inspection: G C T CONSTRUCTION, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of G C T CONSTRUCTION, INC. in 16450 FAIRFIELD DRIVE, PLAINFIELD, IL 60544 (NAICS 238160). OSHA activity number 335963799.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- G C T CONSTRUCTION, INC.
- Site address
- 16450 FAIRFIELD DRIVE
- City
- PLAINFIELD
- State
- IL
- ZIP
- 60544
- Mailing
- 441 DAYWARD COURT, AURORA, IL 60505
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- A
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 5
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.20 B01
- Issued
- Oct 1, 2012
- Abate by
- Oct 23, 2012
- Penalty
- Initial $1,200 · Current $1,400
General-duty citation text
29 CFR 1926.20(b)(1): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part: a. On or about August 23, 2012, at the above addressed jobsite, a safety and health program which would address those hazards associated with the employees' work environment and the company's procedures to eliminate those hazards had not been developed and maintained.
Recent events (2)
- — I (S) $1400
- — Z (S) $1200
1926.20 B02
- Issued
- Oct 1, 2012
- Abate by
- Oct 23, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.20(b)(2): Such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers: a. On or about August 23, 2012, at the above addressed jobsite, safety inspections were not made by persons capable of identifying and correcting those hazards which could result in employee injuries.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.501 B13
- Issued
- Oct 1, 2012
- Abate by
- Oct 2, 2012
- Penalty
- Initial $2,800 · Current $0 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure: a. On or about August 23, 2012, at the above addressed jobsite, employees were exposed to falls of approximately 20 feet (two stories) while working from the various roof pitches (6/12 and 10/12) during the shingling operation.
Recent events (2)
- — I (S) $0
- — Z (S) $2800
1926.503 A01
- Issued
- Oct 1, 2012
- Abate by
- Oct 23, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards: a. On or about August 23, 2012, at the above addressed jobsite, an employee training program addressing fall hazards and the company's procedures to be followed to protect the employees from exposure to those hazards had not been developed and maintained.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.1053 B01
- Issued
- Oct 1, 2012
- Abate by
- Oct 2, 2012
- Penalty
- Initial $2,800 · Current $0 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support: a. on or about August 23, 2012, at the above addressed jobsite, employees accessing and egressing the roof were exposed to falls due to the fact that the ladder did not extend above the roof level so as to allow for a handhold prior to stepping onto the ladder.
Recent events (2)
- — I (S) $0
- — Z (S) $2800
1926.1060 A
- Issued
- Oct 1, 2012
- Abate by
- Oct 23, 2012
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1060(a): The employer shall provide a training program for each employee using ladders and stairways, as necessary. The program shall enable each employee to recognize hazards related to ladders and stairways, and shall train each employee in the procedures to be followed to minimize these hazards: a. On or about August 23, 2012, at the above addressed jobsite, employees had not received training on the safe use of ladders.
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections at G C T Construction, INC.
View G C T Construction, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238160)
More inspections in IL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 335963799.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.