HUNTSVILLE, AL —
OSHA Inspection: H R FRAMING, LLC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of H R FRAMING, LLC. in 97 LEDGE VIEW DR., HUNTSVILLE, AL 35020 (NAICS 238130). OSHA activity number 336528385.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- H R FRAMING, LLC.
- Site address
- 97 LEDGE VIEW DR.
- City
- HUNTSVILLE
- State
- AL
- ZIP
- 35020
- Mailing
- 125 ANTIOCH RD., SOMERVILLE, AL 35670
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 2
- Ownership type
- A
Citations
3 citations on file for this inspection.
1926.451 G01
- Issued
- Sep 27, 2012
- Abate by
- Sep 28, 2012
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section: a. On or about 08/14/12 - 97 Ledge View Dr, Huntsville, AL, two employees were working from a ladder jack scaffold without fall protection.
Recent events (2)
- — I (S) $1400
- — Z (S) $2800
1926.451 B05 II
- Issued
- Sep 27, 2012
- Abate by
- Sep 28, 2012
- Penalty
- Initial $2,400 · Current $1,200 Reduced
General-duty citation text
29 CFR 1926.451(b)(5)(ii): Each platform greater than 10 feet in length shall not extend over its support more than 18 inches (46 cm), unless it is designed and installed so that the cantilevered portion of the platform is able to support employees without tipping, or has guardrails which block employee access to the cantilevered end. a. On or about 08/14/12 - 97 Ledge View Dr, Huntsville, AL, two employees were working from a ladder jack scaffold with the end of the platform extending out too far from the support brace.
Recent events (2)
- — I (S) $1200
- — Z (S) $2400
1926.452 K01
- Issued
- Sep 27, 2012
- Abate by
- Sep 28, 2012
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1926.452(k)(1): Platforms shall not exceed a height of 20 feet (6.1 m). a. On or about 08/14/12 - 97 Ledge View Dr, Huntsville, AL, two employees were working from a ladder jack scaffold approximately 23 feet high.
Recent events (2)
- — I (S) $1400
- — Z (S) $2800
More inspections at H R Framing, LLC.
View H R Framing, LLC.'s full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in AL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 336528385.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.