Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: COUGAR ELECTRONICS & TOOL REPAIR

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of COUGAR ELECTRONICS & TOOL REPAIR in 622 BROADWAY, LONG BRANCH, NJ 07740 (NAICS 332710). OSHA activity number 336857180.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Cougar Electronics & Tool Repair — free Get an email when a new federal OSHA severe-injury report for Cougar Electronics & Tool Repair is published. One employer, no account, unsubscribe in one click.
Site address
622 BROADWAY
City
LONG BRANCH
State
NJ
ZIP
07740
Mailing
622 BROADWAY, LONG BRANCH, NJ 07740
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332710
Employees
10
Ownership type
A

9 citations on file for this inspection.

1910.101 B

Serious Gravity 5 1 instance 3 exposed
Issued
Feb 14, 2013
Abate by
Mar 13, 2013
Penalty
Initial $2,000 · Current $500 Reduced
29 CFR 1910.101(b): The in-plant handling, storage, and utilization of all compressed gases in cylinders, portable tanks, rail tankcars, or motor vehicle cargo tanks were not in accordance with Compressed Gas Association Pamphlet P-1-1965, which is incorporated by reference as specified in CFR 1910.6:    a) Paint Room, 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 the storage of compressed gases in cylinders did not conform to the requirements of the Compressed Gas Association Pamphlet P-1-1965 requiring cylinders to be secured against falling. As a result, employees were exposed to struck-by hazards.    NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (3)
  • — J (S) $500
  • — C (S) $2000
  • — Z (S) $2000

1910.132 F01

Serious Gravity 5 1 instance 3 exposed
Issued
Feb 14, 2013
Abate by
Mar 13, 2013
Penalty
Initial $2,000 · Current $500 Reduced
29 CFR 1910.132(f)(1): The employer did not provide training to each employee who is required by this section to use personal protective equipment:    a) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 the employer did not ensure that each employee was trained in the proper use and care of PPE.    NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (3)
  • — J (S) $500
  • — C (S) $2000
  • — Z (S) $2000

1910.303 B02

Serious Gravity 5 1 instance 2 exposed
Issued
Feb 14, 2013
Abate by
Mar 13, 2013
Penalty
Initial $1,600 · Current $496 Reduced
29 CFR 1910.303(b)(2): Listed or labeled electrical equipment was not used or installed in accordance with instructions included in the listing or labeling:    a) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 a 4x4 metal utility box was improperly mounted on the end of an extension cord, exposing employees to electrical hazards. The utility box was used to power the Parts Washer.     NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (3)
  • — J (S) $496
  • — C (S) $1600
  • — Z (S) $1600

1910.215 B09

Repeat Gravity 5 1 instance 3 exposed
Issued
Feb 14, 2013
Penalty
Initial $3,200 · Current $1,000 Reduced
29 CFR 1910.215(b)(9): The distance between the abrasive wheel periphery(s) and the adjustable tongue or the end of the safety guard peripheral member at the top exceeded one fourth inch:    a) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 employees were exposed to struck-by hazards while using an American Forge & Foundry Bench Grinder with an improperly adjusted tongue guard. The opening between the wheel and the tongue guard was 1 inch.    COUGAR ELECTRONICS & TOOL REPAIR WAS PREVIOUSLY CITED FOR A VIOLATION OF THIS OCCUPATIONAL SAFETY AND HEALTH STANDARD, ITS EQUIVALENT, OR ESSENTIALLY SIMILAR STANDARD, 1910.215(b)(9) WHICH WAS CONTAINED IN OSHA INSPECTION NUMBER 314672742, CITATION 1, ITEM 5b, ISSUED ON 11/1/2010, FINAL ORDER DATE 5/25/2011.
Recent events (3)
  • — J (R) $1000
  • — C (R) $3200
  • — Z (R) $3200

1910.305 G01 IV A

Repeat Gravity 5 1 instance 2 exposed
Issued
Feb 14, 2013
Abate by
Mar 13, 2013
Penalty
Initial $3,200 · Current $1,000 Reduced
29 CFR 1910.305(g)(1)(iv)(A): Flexible cords and/or cables were used as a substitute for the fixed wiring of a structure:    a) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012, the employer used an unapproved extension cord as permanent wiring. The extension cord was used to power a Parts Washer.    COUGAR ELECTRONICS & TOOL REPAIR WAS PREVIOUSLY CITED FOR A VIOLATION OF THIS OCCUPATIONAL SAFETY AND HEALTH STANDARD, ITS EQUIVALENT, OR ESSENTIALLY SIMILAR STANDARD, 1910.305(g)(1)(iv)(A) WHICH WAS CONTAINED IN OSHA INSPECTION NUMBER 314672742, CITATION 1, ITEM 12, ISSUED ON 11/1/2010, FINAL ORDER DATE 5/25/2011.    NOTE: IN ADDITION TO ABATEMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (3)
  • — J (R) $1000
  • — C (R) $3200
  • — Z (R) $3200

1910.305 G02 III

Repeat Gravity 5 1 instance 2 exposed
Issued
Feb 14, 2013
Abate by
Mar 13, 2013
Penalty
Initial $3,200 · Current $1,000 Reduced
29 CFR 1910.305(g)(2)(iii): Flexible cords and cables were not connected to devices and fittings so that strain relief was provided that would prevent pull from being directly transmitted to joints or terminal screws:    a) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 the extension cord powering the Parts Washer did not have adequate strain relief, exposing employees to electrical hazards.     COUGAR ELECTRONICS & TOOL REPAIR WAS PREVIOUSLY CITED FOR A VIOLATION OF THIS OCCUPATIONAL SAFETY AND HEALTH STANDARD, ITS EQUIVALENT, OR ESSENTIALLY SIMILAR STANDARD, 1910.305(g)(2)(iii) WHICH WAS CONTAINED IN OSHA INSPECTION NUMBER 314672742, CITATION 1, ITEM 13, ISSUED ON 11/1/2010, FINAL ORDER DATE 5/25/2011.    NOTE: IN ADDITION TO ABATEMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (3)
  • — J (R) $1000
  • — C (R) $3200
  • — Z (R) $3200

1910.1200 F05 I

Repeat Gravity 5 2 instances 3 exposed
Issued
Feb 14, 2013
Abate by
Mar 13, 2013
Penalty
Initial $4,000 · Current $1,000 Reduced
29 CFR 1910.1200(f)(5)(i): The employer did not ensure that each container of hazardous chemicals in the workplace was labeled, tagged or marked with the identity of the hazardous chemical(s) contained therein:    a) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 containers of oil stored throughout the facility were not properly labeled. A plastic drum containing waste oil was improperly labeled with the words "used anti-freeze only."    b) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 the parts washer containing mineral spirits was not marked to identify the contents therein.    COUGAR ELECTRONICS & TOOL REPAIR WAS PREVIOUSLY CITED FOR A VIOLATION OF THIS OCCUPATIONAL SAFETY AND HEALTH STANDARD, ITS EQUIVALENT, OR ESSENTIALLY SIMILAR STANDARD, 1910.1200(f)(5)(i) WHICH WAS CONTAINED IN OSHA INSPECTION NUMBER 314672742, CITATION 2, ITEM 4b, ISSUED ON 11/1/2010, FINAL ORDER DATE 5/25/2011.    NOTE: IN ADDITION TO ABATEMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (3)
  • — J (R) $1000
  • — C (R) $4000
  • — Z (R) $4000

1910.1200 H01

Repeat Gravity 5 1 instance 3 exposed
Issued
Feb 14, 2013
Abate by
Mar 13, 2013
Penalty
Initial $4,000 · Current $1,000 Reduced
29 CFR 1910.1200(h)(1): Employees were not provided effective information and training on hazardous chemicals in their work area at the time of their initial assignment and whenever a new hazard that the employees had not been previously trained about was introduced into their work area:    a) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 the employer did not ensure that each employee was trained on the hazards associated with the chemicals in their work area.    COUGAR ELECTRONICS & TOOL REPAIR WAS PREVIOUSLY CITED FOR A VIOLATION OF THIS OCCUPATIONAL SAFETY AND HEALTH STANDARD, ITS EQUIVALENT, OR ESSENTIALLY SIMILAR STANDARD, 1910.1200(h)(1) WHICH WAS CONTAINED IN OSHA INSPECTION NUMBER 314672742, CITATION 2, ITEM 4d, ISSUED ON 11/1/2010, FINAL ORDER DATE 5/25/2011.    NOTE: IN ADDITION TO ABATEMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (3)
  • — J (R) $1000
  • — C (R) $4000
  • — Z (R) $4000

1910.132 D01

Other-than-serious 1 instance 3 exposed
Issued
Feb 14, 2013
Abate by
Mar 13, 2013
Penalty
Initial $0 · Current $0
29 CFR 1910.132(d)(1): The employer did not assess the workplace to determine if hazards are present, or are likely to be present, which necessitate the use of personal protective equipment (PPE):    a) 622 Broadway, Long Branch, NJ 07740: On or about October 11, 2012 the employer failed to perform a hazard assessment, exposing employees to flying particles and chemical hazards.     NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (3)
  • — J (O) $0
  • — C (O) $0
  • — Z (O) $0

View Cougar Electronics & Tool Repair's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 336857180.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.