STRATFORD, CT —
OSHA Inspection: RICARDO REMODELING LLC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of RICARDO REMODELING LLC in 125 VICTORIA LAWN, STRATFORD, CT 06615 (NAICS 238160). OSHA activity number 337710214.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- RICARDO REMODELING LLC
- Site address
- 125 VICTORIA LAWN
- City
- STRATFORD
- State
- CT
- ZIP
- 06615
- Mailing
- 226 HOUSTON AVENUE, BRIDGEPORT, CT 06606
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 5
- Ownership type
- A
Citations
7 citations on file for this inspection.
1926.100 A
- Issued
- Feb 8, 2013
- Abate by
- Feb 19, 2013
- Penalty
- Initial $1,600 · Current $1,120 Reduced
General-duty citation text
29 CFR 1926.100(a): Employees working in areas where there is a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns, shall be protected by protective helmets. WORKSITE: The employee cleaning debris below the employees on the roof was not wearing a hardhat.
Recent events (2)
- — I (S) $1120
- — Z (S) $1600
1926.501 B13
- Issued
- Feb 8, 2013
- Abate by
- Feb 19, 2013
- Penalty
- Initial $2,800 · Current $1,960 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. WORKSITE: The employees performing roofing activities on the 11/12 pitch roofs of a single family house without adequate fall protection, exposing the employees to falls between 9 feet 6 inches and 10 feet 2 inches.
Recent events (2)
- — I (S) $1960
- — Z (S) $2800
1926.1053 B01
- Issued
- Feb 8, 2013
- Abate by
- Feb 19, 2013
- Penalty
- Initial $2,000 · Current $1,400 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support. WORKSITE: The 14 foot aluminum straight ladder, used by employees to access the garage roof did not extend at least three (3) feet above the roof eave and no handhold or equivalent was provided.
Recent events (2)
- — I (S) $1400
- — Z (S) $2000
1926.1053 B07
- Issued
- Feb 8, 2013
- Abate by
- Feb 19, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(7): Ladders shall not be used on slippery surfaces unless secured or provided with slip-resistant feet to prevent accidental displacement. Slip-resistant feet shall not be used as a substitute for care in placing, lashing, or holding a ladder that is used upon slippery surfaces including, but not limited to, flat metal or concrete surfaces that are constructed so they cannot be prevented from becoming slippery. WORKSITE: A 16 foot aluminum straight ladder used by employees to access the main roof, was set on the plastic end caps on the side rails and the ladder was not secured to prevent accidental displacement.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.1053 B09
- Issued
- Feb 8, 2013
- Abate by
- Feb 19, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(9): The area around the top and bottom of ladders shall be kept clear. WORKSITE: The aluminum straight ladders, used by employees to access the following roofs were placed on top of the construction debris pile.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.1053 B21
- Issued
- Feb 8, 2013
- Abate by
- Feb 19, 2013
- Penalty
- Initial $2,000 · Current $1,400 Reduced
General-duty citation text
29 CFR 1926.1053(b)(21): Each employee shall use at least one hand to grasp the ladder when progressing up and/or down the ladder. WORKSITE: The employee, carrying bundle(s) of shingles on his shoulder while climbing the ladder, was unable to maintain three points of contact with the ladder at all times.
Recent events (2)
- — I (S) $1400
- — Z (S) $2000
1926.1053 B22
- Issued
- Feb 8, 2013
- Abate by
- Feb 19, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(22): An employee shall not carry any object or load that could cause the employee to lose balance and fall. WORKSITE: The employee was manually carrying bundles of shingles up the ladders to the roof.
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections at Ricardo Remodeling LLC
View Ricardo Remodeling LLC's full OSHA safety record →
More inspections in this industry (NAICS 238160)
More inspections in CT
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 337710214.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.