Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: C.I.M.J. LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of C.I.M.J. LLC in 104 BROADWAY, MILFORD, CT 06460 (NAICS 238130). OSHA activity number 337834014.

Watch C.I.M.J. LLC — free Get an email when a new federal OSHA severe-injury report for C.I.M.J. LLC is published. One employer, no account, unsubscribe in one click.
Establishment
C.I.M.J. LLC
Site address
104 BROADWAY
City
MILFORD
State
CT
ZIP
06460
Mailing
105 DURHAM ROAD, GUILFORD, CT 06437
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

8 citations on file for this inspection.

1926.102 A01

Serious Gravity 1 2 instances 2 exposed
Issued
Penalty
Initial $1200.00 · Current $800.00 Reduced
29 CFR 1926.102(a)(1):  Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical, chemical, or radiation agents:    JOBSITE:  The employees, operating  circular saws to cut wood were not wearing eye protection.
Recent events (2)
  • — I (S) $800
  • — Z (S) $1200

1926.501 B13

Serious Gravity 5 2 instances 3 exposed
Issued
Abate by
Penalty
Initial $2000.00 · Current $1200.00 Reduced
29 CFR 1926.501(b)(13):  Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):     JOBSITE:      1. The employee, performing framing of a house was exposed to the hazard of falling 19 feet 10 inches to the ground.    2. The employees, engaged in framing or cleaning debris were exposed to the hazard of falling 12 feet 10 inches to the ground at the south side open-sided edge of the 1st level of the house.
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

1926.502 B02

Serious Gravity 5 1 instance 3 exposed
Issued
Penalty
Initial $2000.00 · Current $1200.00 Reduced
29 CFR 1926.502(b)(2):  Midrails, screens, mesh, intermediate vertical members, or equivalent intermediate structure members were not installed between the top edge of the guardrail system and the walking/working surface when there was no wall or parapet wall at least 21 inches (53 cm) high.    JOBSITE:  The guardrail system, installed around the floor opening was not equipped with midrails.
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

1926.503 A01

Serious Gravity 5 2 instances 3 exposed
Issued
Abate by
Penalty
Initial $2000.00 · Current $1200.00 Reduced
29 CFR 1926.503(a)(1):  The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:    JOBSITE:  The employees exposed to the hazard of falling while performing framing and cleaning debris were not provided with information and training to control or minimize such hazards.
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

1926.1060 A

Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.1060(a):  The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards.  Note:  29 CFR 1926.21(b)(2) may be cited as an additional violation to support this requirement.    JOBSITE:  The employees, using a 20 foot aluminum extension ladder to have access to an upper working level were not provided with information and training regarding the safe use and handling of the ladder.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1051 A

Serious Gravity 5 1 instance 2 exposed
Issued
Penalty
Initial $2000.00 · Current $1200.00 Reduced
29 CFR 1926.1051(a):  Stairway(s) or ladder(s) were not provided at all personnel points of access where there was a break in elevation of 19 inches (48 cm) or more, or no ramp, runway, sloped embankment, or personnel hoist was provided:    JOBSITE:  The wall, used as the employees point of access to the first level and having a break in elevation of more than 19 inches was not provided with a step, ramp or an equivalent device.
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

1926.1053 B01

Serious Gravity 5 1 instance 2 exposed
Issued
Penalty
Initial $2000.00 · Current $1200.00 Reduced
29 CFR 1926.1053(b)(1):  Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:    JOBSITE:  The side rails of the aluminum extension ladder, used by the employees as a means of access to the 1st level working deck did not extend at least 3 feet above the 1st level working deck.
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

1926.1053 B05 I

Serious Gravity 5 1 instance 2 exposed
Issued
Penalty
Initial $2000.00 · Current $1200.00 Reduced
29 CFR 1926.1053(b)(5)(i):  Non-self-supporting ladder(s) were not used at an angle such that the horizontal distance from the top support to the foot of the ladder was approximately one-quarter of the working length of the ladder (the distance along the ladder between the foot and the top support):    JOBSITE:  The horizontal distance from the vertical support to the base of the 20 foot aluminum extension ladder which was used by the employees to access the first level of a house was more than one fourth (1/4) of the working length of the ladder.
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2000

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 337834014.