CROSSVILLE, AL —
OSHA Inspection: ASHLEY MASONRY, INC.
Federal Agency inspection · Safety discipline
At a glance
On , OSHA opened a federal Agency safety inspection of ASHLEY MASONRY, INC. in 15755 HIGHWAY 68, CROSSVILLE, AL 35962 (NAICS 238140). OSHA activity number 337930218.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ASHLEY MASONRY, INC.
- Site address
- 15755 HIGHWAY 68
- City
- CROSSVILLE
- State
- AL
- ZIP
- 35962
- Mailing
- 164 COUNTY ROAD 89, FORT PAYNE, AL 35967
What kind of inspection was it?
- Inspection type
- Federal Agency (M)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238140
- Employees
- 8
- Ownership type
- A
Citations
5 citations on file for this inspection.
5(a)(1)
- Issued
- Mar 18, 2013
- Abate by
- Mar 22, 2013
- Penalty
- Initial $4,900 · Current $4,900
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall and struck-by hazards: On or about 12/18/12 - At 15755 AL Highway 68, Crossville, AL, the Lull forklift boom and load were not lowered before the operator left the seat then stood on the operator's step and leaned into the cab to adjust the new seat's nuts and bolts.
Recent events (1)
- — Z (S) $4900
1926.451 A06
- Issued
- Mar 18, 2013
- Abate by
- Mar 26, 2013
- Penalty
- Initial $2,000 · Current $2,000
General-duty citation text
29 CFR 1926.451(a)(6): Scaffolds were not constructed in accordance with the design by a qualified person: (a) On or about 12/18/12 - At 15755 AL Highway 68, Crossville, AL, the self-contained adjustable EZ Heavy Duty Commercial Tower Scaffold was not constructed in accordance with the design in that the bridges were not installed with the crown of the truss facing up.
Recent events (1)
- — Z (S) $2000
1926.451 C01 II
- Issued
- Mar 18, 2013
- Abate by
- Mar 22, 2013
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.451(c)(1)(ii): Guys, ties, and/or braces were not installed according to the scaffold manufacturer's recommendations or at the closest horizontal member to the 4:1 height and repeated vertically at locations of horizontal members every 20 feet (56.1 m) or less thereafter for scaffolds 3 feet ((0.91 m) wide or less, and every 26 feet (7.9 m) or less thereafter for scaffolds greater than 3 feet (0.91m) wide: (a) On or about 12/18/12 - At 15755 AL Highway 68, Crossville, AL, employees were working on scaffold that was not guyed, tied and/or braced according to the scaffold manufacturer's recommendations in that there were no 2x4 timbers, putlogs or scaffold members placed between the masonry wall and the scaffold to protect the scaffold from tipping into the wall due to compressive loads.
Recent events (1)
- — Z (S) $2800
1926.451 G01 IV
- Issued
- Mar 18, 2013
- Abate by
- Mar 22, 2013
- Penalty
- Initial $2,000 · Current $2,000
General-duty citation text
29 CFR 1926.451(g)(1)(iv): Each employee on a self-contained adjustable scaffold shall be protected by a guardrail system (with minimum 200 pound toprail capacity) when the platform is supported by the frame structure, and by both a personal fall arrest system and a guardrail system (with minimum 200 pound toprail capacity) when the platform is supported by ropes: (a) On or about 12/18/12 - At 15755 AL Highway 68, Crossville, AL, employees were exposed to a fall hazard of approximately 25 feet while removing concrete block from the pallet which was set down on the scaffold platform located outside of the guardrail system. The mid rail was removed and employees had to reach through and under the top rail in order to retrieve the concrete block and were exposed to a fall hazard when the level of concrete block was one tier high.
Recent events (1)
- — Z (S) $2000
1926.602 C01 I
- Issued
- Mar 18, 2013
- Abate by
- Mar 26, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.602(c)(1)(i): Lifting and hauling equipment did not have the rated capacity clearly posted on the vehicle so as to be clearly visible to the operator: (a) On or about 12/18/12 - At 15755 AL Highway 68, Crossville, AL, the rated capacity was not posted on the Lull Highlander model 644D-34, S/N 00AL25W24-1414 that was lifting concrete masonry units.
Recent events (1)
- — Z (O) $0
More inspections at Ashley Masonry, INC.
View Ashley Masonry, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238140)
More inspections in AL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 337930218.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.